This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Rubber: Fluorocarbon Elastomer (FKM) Low Temperature Sealing Tg -40 °F (-40 °C) 70 to 80 Type ‘A’ Hardness For Elastomeric Seals in Aircraft Engine Oil, Fuel and Hydraulics Systems
- Aerospace Material Specification
Published May 18, 2020 by SAE International in United States
Downloadable datasets availableAnnotation ability available
This specification covers a fluorocarbon (FKM) rubber in the form of O-rings, compression seals, O-ring cord, and molded-in-place gaskets for aeronautical and aerospace applications. For sheet, strip, tubing, extrusions, and molded shapes use the AMS3353 specification which is intended for that use.
Specification has been revised to change the glass transition testing method from ASTM D3418 to ASTM D7426, as well as a general update of the specification to the latest format.
Data Sets - Support Documents
|[Unnamed Dataset 1]|
|[Unnamed Dataset 2]|
|[Unnamed Dataset 3]|
|[Unnamed Dataset 4]|
|Table 1||Qualification properties|
|Table 2||Batch test|
|Table 3||Acceptance lot test for O-rings|
|Table 4||Acceptance lot test for all other seal geometries except plate seals and O-rings|
Welcome to the AMS-CE Elastomers Committee Discussion Forum.The AMS-CE Elastomers Committee maintains Aerospace Materials Specifications (AMS), Aerospace Recommended Practices (ARP), Aerospace Information Reports (AIR) and Aerospace Standards (AS) on elastomeric materials. AMS-CE, which reports to the Aerospace Materials Division, coordinates and maintains liaison with industry, government and other standardization groups on elastomeric materials. A significant part of this committee is concerned with elastomeric fluid sealing materials, their applications, material development, testing, quality, design parameters and design practices. No copyrighted material may be posted in this forum. SAE is not liable for opinions expressed or information posted to this forum. All information posted becomes the property of SAE.
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.