This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Rubber: Butyl (IIR Abbreviation) Phosphate Ester Resistant 65 to 75 Hardness for Seals in Hydraulic Systems, etc.
- Aerospace Material Specification
Published July 18, 2019 by SAE International in United States
Downloadable datasets availableAnnotation ability available
This specification covers a butyl rubber in the form of molded rings, compression seals, o-ring cord, and molded-in-place gaskets for aeronautical and aerospace applications. As AMS3238 is no longer valid for O-rings. For O-rings, the requirements of AMS7338 shall be met wherever AMS3238 is specified.
This document has been determined to contain basic and stable technology which is not dynamic in nature.
|Aerospace Material Specification||Rings, Sealing, Silicone Rubber Low Compression Set, Non-Oil Resistant 65 - 75|
|Aerospace Material Specification||Silicone Rubber Extreme Low-Temperature Resistant 45 - 55|
|Aerospace Standard||SEAL, BONDED, 302 CORROSION RESISTANT STEEL, AMS5516, MOLD IN GROOVE, FLUOROSILICONE RUBBER, MIL-DTL-25988|
Data Sets - Support Documents
|[Unnamed Dataset 1]|
|[Unnamed Dataset 2]|
|[Unnamed Dataset 3]|
|[Unnamed Dataset 4]|
|TABLE 2||Acceptance Tests|
Welcome to the AMS-CE Elastomers Committee Discussion Forum.The AMS-CE Elastomers Committee maintains Aerospace Materials Specifications (AMS), Aerospace Recommended Practices (ARP), Aerospace Information Reports (AIR) and Aerospace Standards (AS) on elastomeric materials. AMS-CE, which reports to the Aerospace Materials Division, coordinates and maintains liaison with industry, government and other standardization groups on elastomeric materials. A significant part of this committee is concerned with elastomeric fluid sealing materials, their applications, material development, testing, quality, design parameters and design practices. No copyrighted material may be posted in this forum. SAE is not liable for opinions expressed or information posted to this forum. All information posted becomes the property of SAE.
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.