This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Nickel Alloy, Corrosion and Heat-Resistant, Powder for Additive Manufacturing, 60Ni - 22Cr - 2.0Mo - 14W - 0.35Al - 0.03La
- Aerospace Material Specification
Published January 03, 2019 by SAE International in United States
Downloadable datasets availableAnnotation ability available
The intended upper bound of this specification is that the particle size distribution (PSD) of powders supplied shall be <60 mesh (250 µm) and that no powder (0.0 wt.%) greater than 40 mesh (425 µm) is allowed.
To provide a specification that will allow Alloy 230 to be procured in the aerospace supply chain for use in additive manufacturing.
|Aerospace Material Specification||Nickel Alloy, Corrosion and Heat-Resistant, Powder for Additive Manufacturing, 47.5Ni - 22Cr - 1.5Co - 9.0Mo - 0.60W - 18.5Fe|
|Aerospace Material Specification||Precipitation Hardenable Steel Alloy, Corrosion and Heat-Resistant Powder for Additive Manufacturing 16.0Cr - 4.0Ni - 4.0Cu - 0.30Nb|
Data Sets - Support Documents
|Unnamed Dataset 1|
|Unnamed Dataset 2|
|Table 2||Oxygen limits based on powder classification|
|Table 3||Particle size distribution based on powder classification|
|Table 4||Testing requirements|
Welcome to the SAE AMS AM, Additive Manufacturing public forum area.Scope: AMS AM is a technical committee in SAE’s Aerospace Materials Systems Group with the responsibility to develop and maintain aerospace material and process specifications and other SAE technical reports for additive manufacturing, including precursor material, additive processes, system requirements and post-build materials, pre-processing and post-processing, non-destructive testing and quality assurance.
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.