This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Potting Compound, Epoxy Bisphenol A-Type Filled, Heat Cure, Machinable
- Aerospace Material Specification
Published September 22, 2016 by SAE International in United States
This specification covers an epoxy resin formulation with fillers such as calcium carbonate, supplie as a two-component system, requiring an oven cure for attainment of maximum properties.
Cancel due to inaccurate technical requirements.
|Aerospace Material Specification||Potting Compound, Epoxy Bisphenol A-Type Unfilled, Room Temperature Cure|
|Aerospace Material Specification||Potting Compound, Epoxy Bisphenol A-Type Filled, Heat Cure, Low CTE Thermal Shock Resistant|
|Aerospace Material Specification||Potting Compound, Epoxy Bisphenol A-Type Impregnating Resin, Heat Cure, Single Component|
Data Sets - Support Documents
No Datasets Available
Welcome to the AMS-P Polymeric & Composites Materials Committee discussion forum.The AMS-P Polymeric Materials Committee writes and revises Aerospace Material Specifications (AMS), Metric Aerospace Materials Specifications (MAM), Aerospace Recommended Practices (ARP), and Aerospace Information Reports (AIR) for composite material technology as assigned to the committee. No copyrighted material may be posted in this forum. SAE is not liable for opinions expressed or information posted to this forum. All information posted becomes the property of SAE.
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.