This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Type 10 Virgin Polytetrafluoroethylene (PTFE) Moldings or Extrusions with 15% Carbon Fiber
- Aerospace Material Specification
Published February 29, 2016 by SAE International in United States
Downloadable datasets availableAnnotation ability available
This specification covers a polytetrafluoroethylene (PTFE) resin filled with carbon fiber in the form of extruded or molded rods or tubes which are sintered after molding or, in the case of extrusions, sintered during the extrusion process.
This document has been determined to contain basic and stable technology which is not dynamic in nature.
|Aerospace Material Specification||Type 8 Virgin Polytetrafluoroethylene (PTFE) Moldings or Extrusions with 10% Carbon Fiber|
|Aerospace Material Specification||Type 5 Virgin Polytetrafluoroethylene (PTFE) Moldings or Extrusions with Pigment|
|Aerospace Material Specification||Type 2 15% Graphite Filled Virgin Polytetrafluoroethylene (PTFE) Moldings or Extrusions|
Data Sets - Support Documents
|TABLE 1||MATERIAL PROPERTY REQUIREMENTS|
Welcome to the AMS-P Polymeric & Composites Materials Committee discussion forum.The AMS-P Polymeric Materials Committee writes and revises Aerospace Material Specifications (AMS), Metric Aerospace Materials Specifications (MAM), Aerospace Recommended Practices (ARP), and Aerospace Information Reports (AIR) for composite material technology as assigned to the committee. No copyrighted material may be posted in this forum. SAE is not liable for opinions expressed or information posted to this forum. All information posted becomes the property of SAE.
|AMS3678D||Polytetrafluoroethylene (PTFE) Moldings and Extrusions Unfilled, Pigmented, and Filled|
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.