This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Polytetrafluoroethylene (PTFE) Moldings General Purpose Grade, As Sintered
- Aerospace Material Specification
Published August 25, 2011 by SAE International in United States
Downloadable datasets availableAnnotation ability available
This specification covers virgin, unfilled polytetrafluoroethylene (PTFE) in the form of molded rods, tubes, and shapes. This specification does not apply to product over 12 inches (305 mm) in dimension parallel to the direction of applied molding pressure, rods under 0.750 inch (19.05 mm) in diameter, and tubes having wall thickness under 0.500 inch (12.70 mm).
This document has been determined to contain basic and stable technology which is not dynamic in nature.
|Aerospace Material Specification||Polytetrafluoroethylene (PTFE) Sheet, Molded General Purpose Grade, As Sintered|
|Aerospace Material Specification||Polytetrafluoroethylene (PTFE) Sheet, Molded Premium Grade, As Sintered|
|Aerospace Material Specification||Chloroprene (CR) Rubber Weather Resistant 45 - 55|
Data Sets - Support Documents
|[Unnamed Dataset 1]|
|TABLE 2||DIAMETER TOLERANCES|
|TABLE 3||DIAMETER TOLERANCES|
|TABLE 4A||MAXIMUM OUT OF ROUNDNESS TOLERANCES|
|[Unnamed Dataset 6]|
Welcome to the AMS-P Polymeric & Composites Materials Committee discussion forum.The AMS-P Polymeric Materials Committee writes and revises Aerospace Material Specifications (AMS), Metric Aerospace Materials Specifications (MAM), Aerospace Recommended Practices (ARP), and Aerospace Information Reports (AIR) for composite material technology as assigned to the committee. No copyrighted material may be posted in this forum. SAE is not liable for opinions expressed or information posted to this forum. All information posted becomes the property of SAE.
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.