This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Sponge, Chloroprene (CR) Rubber Firm
- Aerospace Material Specification
Published May 08, 2014 by SAE International in United States
Downloadable datasets availableAnnotation ability available
This specification covers a chloroprene (CR) rubber sponge in the form of sheet, strip, molded shapes, or other forms, as ordered.
This document has been determined to contain basic and stable technology which is not dynamic in nature.
|Aerospace Material Specification||Rings, Sealing, Silicone Rubber Low Compression Set, Non-Oil Resistant 65 - 75|
|Aerospace Material Specification||Silicone (PVMQ) Rubber Extreme-Low-Temperature Resistant 75 - 85|
Data Sets - Support Documents
|TABLE 1||Specific Volume|
|TABLE 2A||Thickness Tolerance, Inch/Pound Units|
|TABLE 2B||Thickness Tolerance, SI Units|
|TABLE 3A||Width Tolerance, Inch/Pound Units|
|TABLE 3B||Width Tolerance, SI Units|
Welcome to the AMS-CE Elastomers Committee Discussion Forum.The AMS-CE Elastomers Committee maintains Aerospace Materials Specifications (AMS), Aerospace Recommended Practices (ARP), Aerospace Information Reports (AIR) and Aerospace Standards (AS) on elastomeric materials. AMS-CE, which reports to the Aerospace Materials Division, coordinates and maintains liaison with industry, government and other standardization groups on elastomeric materials. A significant part of this committee is concerned with elastomeric fluid sealing materials, their applications, material development, testing, quality, design parameters and design practices. No copyrighted material may be posted in this forum. SAE is not liable for opinions expressed or information posted to this forum. All information posted becomes the property of SAE.
|AMS2810||IDENTIFICATION OF NATURAL AND SYNTHETIC RUBBER MATERIALS|
|ASTMD1056||This document is not part of the subscrption.|
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.