This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Tolerances Rubber Products
- Aerospace Material Specification
Published November 07, 2011 by SAE International in United States
Downloadable datasets availableAnnotation ability available
This specification covers established inch/pound manufacturing tolerances applicable to non-cellular rubber products ordered to inch/pound dimensions. These tolerances apply to all conditions, unless otherwise noted. The term "exclusive" applies only to the higher figure of the specified range.
This document has been determined to contain basic and stable technology which is not dynamic in nature.
|Aerospace Standard||O-RING, STRAIGHT THREAD TUBE FITTING BOSS MOLDED FROM AMS-P-5510 RUBBER|
|Aerospace Standard||PACKING, PREFORMED - MS28775 O-RING|
|Aerospace Material Specification||Identification and Packaging Elastomeric Products|
Data Sets - Support Documents
|TABLE 1||Thickness Tolerances|
|TABLE 2||Width Tolerances|
|TABLE 6||Length Tolerances|
|TABLE 7||Length Tolerances|
Welcome to the AMS-CE Elastomers Committee Discussion Forum.The AMS-CE Elastomers Committee maintains Aerospace Materials Specifications (AMS), Aerospace Recommended Practices (ARP), Aerospace Information Reports (AIR) and Aerospace Standards (AS) on elastomeric materials. AMS-CE, which reports to the Aerospace Materials Division, coordinates and maintains liaison with industry, government and other standardization groups on elastomeric materials. A significant part of this committee is concerned with elastomeric fluid sealing materials, their applications, material development, testing, quality, design parameters and design practices. No copyrighted material may be posted in this forum. SAE is not liable for opinions expressed or information posted to this forum. All information posted becomes the property of SAE.
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.