This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Landing Gear Manufacturing, Maintenance, Repair, and Overhaul Critical Processes
- Aerospace Standard
- AIR6813
- Issued
Sector:
Issuing Committee:
Language:
English
Scope
CPs are a process that is executed on a critical landing gear (or undercarriage) part, assembly or equipment that if performed incorrectly or omitted would cause:
-
An operational failure of the aircraft; or
-
An unacceptable risk of injury
This document identifies CPs that have either caused operational failure or that can be reasonably expected to cause operational failures based on experience. Note that in the interest of brevity, that this document is not intended to be a definitive listing, only an introduction and a consideration of common processes.
Rationale
This SAE Aerospace Information Report (AIR) provides guidelines and useful references for Critical Processes (CPs) and related lessons learned for structural landing gear systems for an aircraft. It is intended as information only, and should not be used as a mandatory requirement specification.
Topic
Data Sets - Support Documents
No Datasets Available
Issuing Committee
Reference
Number | Title |
---|
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.