This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Aerospace - Chlorinated Solvent Contamination of MIL-H-5606/MIL-H-83282 Vehicle Hydraulic Systems
- Aerospace Standard
- AIR4713
- Reaffirmed
Downloadable datasets available
Annotation ability available
Sector:
Issuing Committee:
Language:
English
Scope
Although there is controversy regarding the chemical form of chlorine and its relation to harmful effects in the hydraulic fluid (i.e., chloride ions versus organic chloro-compounds versus total chlorine in all forms), it is generally agreed that total chlorine content should be measured and controlled. In the near future, the ban on the manufacture of chlorinated solvents, out of concern for depletion of the ozone layer, may in itself diminish or eliminate chlorine contamination related aircraft malfunctions. It is generally accepted that hydraulic fluid contamination should be held to a minimum under all conditions. The benefits of low contamination levels are improved performance, lower maintenance due to lower wear, corrosion and erosion, longer fluid life, longer component life, etc.
Contaminants can be classified into two general types: those that are insoluble and those that are soluble in the hydraulic fluid. The insoluble solid type is most common and is usually referred to as particulate matter. Its measurement and removal have been the subject of much investigation and standardization which is well documented in technical literature. The insoluble liquid type contaminant is much less common. The resulting two phase system is often observed as hazy or cloudy fluid appearance and the recommended action is to remove the contaminated hydraulic fluid from the system.
Soluble type contaminants are more difficult to detect and to determine quantitatively. They can easily escape notice, particularly when present in small amounts. Gross contamination usually results in significant changes in fluid physical properties and can be determined by such changes. Smaller amounts are difficult to detect and measure and usually require sophisticated analytical techniques -such as infrared and other spectral techniques, gas chromatography (both head space and electron capture), microcoulometry, x-ray fluorescence, etc.
Generally, the presence of undesirable soluble contaminants is unknown until they have been shown to cause performance problems. Hydraulic fluid formulations contain soluble additives in base stocks giving beneficial effects on performance. The range of possible undesirable soluble contaminants can encompass innumerable materials - solids, liquids or gases.
Recommended Content
Aerospace Standard | Aerospace - Chlorinated Solvent Contamination of MIL-H-5606/MIL-H-83282 Vehicle Hydraulic Systems |
Aerospace Standard | Air in Aircraft Hydraulic Systems |
Aerospace Standard | Aircraft Maintenance Jacks - General Requirements |
Topic
Data Sets - Support Documents
Title | Description | Download |
---|---|---|
Unnamed Dataset 1 | ||
Unnamed Dataset 2 |
Issuing Committee
A-6C1 Fluids and Contamination Control Committee
A6C1 is responsible for the development of standards, processes, and practices related to Aerospace Fluids and Systems' cleanliness in aerospace engines, hydraulic systems and missiles, and the integration of these components for Commercial and Military air vehicles. The panel provides a forum for government engineers, prime contractors, and suppliers to exchange technical information, regulatory updates, recent technology developments, issues related to system development and in service operation and lessons learned.
Reference
Number | Title |
---|---|
AIR810 | DEGRADATION LIMITS OF MIL-H-5606 HYDRAULIC FLUID |
MIL-H-5440 | This document is not part of the subscrption. |
MIL-H-5606 | This document is not part of the subscrption. |
MIL-H-83282 | This document is not part of the subscrption. |
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.