This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
The Effects of Chassis Flexibility on Roll Stiffness of a Winston Cup Race Car
Annotation ability available
Sector:
Language:
English
Abstract
Predictable handling of a racecar may be achieved by tailoring chassis stiffness so that roll stiffness between sprung and unsprung masses are due almost entirely to the suspension. In this work, the effects of overall chassis flexibility on roll stiffness and wheel camber response, will be determined using a finite element model (FEM) of a Winston Cup racecar chassis and suspension. The FEM of the chassis/suspension is built from an assembly of beam and shell elements using geometry measured from a typical Winston cup race configuration. Care has been taken to model internal constraints between degrees-of-freedom (DOF) at suspension to chassis connections, e.g.
t ball and pin joints and internal releases.
To validate the model, the change in wheel loads due to an applied jacking force that rolls the chassis agrees closely with measured data. The roll stiffness predicted from finite element models of the front and rear suspension compared closely to those calculated using a rigid-body kinematics model. To study the effects of chassis flexibility on roll, torsional stiffness is increased by adding strategic members to the chassis structure. Results from the finite element analysis indicate that the effective roll stiffness of the front suspension interacting with the chassis, increased by 7.3 % over a baseline chassis when the chassis torsional stiffness was increased by 130% over a baseline chassis stiffness of 9934 ft-lb/deg. As the chassis stiffness is increased further above this value, the front roll stiffness changed very little. From these results, the minimum torsional stiffness required so that the effective roll stiffness of the front suspension is within 3 % from the roll stiffness with a rigid chassis, is about 23100 ft-lb/deg.
Recommended Content
Authors
Citation
Thompson, L., Soni, P., Raju, S., and Law, E., "The Effects of Chassis Flexibility on Roll Stiffness of a Winston Cup Race Car," SAE Technical Paper 983051, 1998, https://doi.org/10.4271/983051.Also In
References
- Martin, Gerald “Revolution or Relic? Is Hendrick Motorsports’ Stiff Chassis Monte Carlo the Wave of the Future of Just Another Dinosaur?” RACER Magazine 32 36 1997
- Raju, Srikanth “Design and Analysis of a Winston Cup Stock Car Chassis for Torsional Stiffness using the Finite Element Method” Department of Mechanical Engineering, Clemson University August 1998
- Keiner, Henning “Static Structural Analysis of a Winston Cup Chassis under a Torsional Load” Department of Mechanical Engineering, Clemson University 1995
- Crawford John “Finite Element Analysis of a NASCAR Winston Cup Stock Car” SAE Paper No. 942527 SAE Motorsports Engineering Conference Detroit, MI December 1994
- Lampert, Jon K. “Design and Analysis of a Twist Fixture to measure the Torsional Stiffness of a Winston Cup Chassis” Department of Mechanical Engineering, Clemson University August 1998
- NASCAR Winston Cup Rule Book 1997
- Integrated Design Engineering Analysis Software Master Series 5 Computer Software Structural Dynamics Research Corporation 1997
- Day, Kent A. Doctor of Philosophy Dissertation Department of Mechanical Engineering, Clemson University
- Herrick, Gregory “The Effects of Spring Perch Flexibility on Front Suspension Geometry and Roll Stiffness of a Winston Cup Stock Car Using the Finite Element Method” Department of Mechanical Engineering, Clemson University August 1998
- Soni, Pipasu H. “Effects of Chassis Flexibility on Roll Stiffness of a Winston Cup Stock Car Using the Finite Element Method” Department of Mechanical Engineering, Clemson University May 1998
- Day, Kent A. Law, E. “Effects of Suspension Geometry and Stiffness Asymmetries on Wheel Loads During Steady Cornering for a Winston Cup Car” SAE Motorsports Engineering Conference, SAE Paper No. 962531 1996