This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
A Study of Gel Index and MRV Effects on SAE 5W-30 Pumpability
Annotation ability available
Sector:
Language:
English
Abstract
Today's engine oil formulators must continually balance performance in various low temperature rheological tests including Mini Rotary Viscosity (MRV), Scanning Brookfield Gel Index, Pour Point, etc. Frequently, optimization against one low temperature specification leads to sub-optimal performance in another, a direct consequence of significant differences in the cooling rates and shear rate/shear stress regimes employed in the tests. To better understand the implications of these differences in rheological properties, laboratory and vehicle low temperature tests were undertaken on a series of SAE 5W-30 oils with different combinations of gel index and MRV properties, but no direct correlation between the two. Full scale motored pumpability testing in pairs of modern 4- and 8- cylinder engines were conducted at ambient temperatures between -35 and -38°C (below the anticipated minimum start temperatures (MST's) of the vehicles). Pumpability testing showed acceptable performance in all the engines at temperature below the vehicles' MST. No correlation to the oils gel index was observed for either pressurization times or air-binding tendencies. However, pressurization times at the lowest temperatures did correspond to the MRV ranking of the oils. Significant pumpability differences were noted among the engines which may be associated with design and hardware differences. Analysis of the used lubricants after the motored pumpability testing also demonstrated some changes in gel index values, although MRV viscosities were comparable.
Recommended Content
Authors
Citation
Koenitzer, B., Lai, P., and May, C., "A Study of Gel Index and MRV Effects on SAE 5W-30 Pumpability," SAE Technical Paper 982641, 1998, https://doi.org/10.4271/982641.Also In
References
- “Determination of Yield Stress and Apparent Viscosity of Engine Oils at Low Temperature” ASTM Standard Test Method D4684
- Henderson K.O. Manning R.E. May C.J. Rhodes R.B. “New Mini-Rotary Viscometer Temperature Profiles That Predict Engine Oil Pumpability” SAE Paper No. 850443
- “Low Temperature, Low Shear Rate Viscosity/ Temperature Profile of Lubricating Oils Using a Temperature- Scanning Technique” ASTM Standard Test Method D5133
- Selby T.W. Piasecki D.A. “Low Shear, Low Temperature Properties of Engine Oils - Techniques with the Brookfield Viscometer” SAE Paper No. 800367
- Selby T.W. “The Scanning Brookfield Technique of Low-Temperature, Low-Shear Rheology - Its Inception, Development, and Applications” ASTM STP 1143 1992
- Selby T.W. “Problems in Bench Test Prediction of Engine Oil Performance at Low Temperature” SAE Paper No. 922287
- Selby T.W. “The Use of the Scanning Brookfield Technique to Study the Critical Degree of Gelation of Lubricants at Low Temperatures” SAE Paper No. 910746
- J-300 Dec. 95
- Engine Oil Licensing and Certification System 14th December 1996 D-6
- Henderson K.O. Sicking J.M. “The Effect of Shear Rate and Shear Stress on Viscosity Determinations at Low Temperatures for Engine Oils” SAE Paper No. 902091
- ASTM DS-57 “Low Temperature Pumpability Characteristics of Engine Oils in Full Scale Engines” ASTM Philadelphia Sept. 1975
- “Low-Temperature Properties of Engine Oils” Lubrizol NewsLine 16 1 February 1998