This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Exhaust Gas Recirculation in a Lean-Burn Natural Gas Engine
Annotation ability available
Sector:
Language:
English
Abstract
Lean-burn natural gas engines offer attractively low particulate matter emissions and enjoy higher efficiencies than their stoichiometric counterparts. However, even though oxides of nitrogen emissions can be reduced through operation at lambda ratios of greater than 1.3, catalysts cannot reduce the oxides of nitrogen emissions in the oxidizing exhaust environment. Exhaust Gas Recirculation (EGR) offers the potential to reduce engine out oxides of nitrogen emissions by reducing the flame temperature and oxygen partial pressure that encourages their formation during the combustion process. A comparative study involving a change in the nature of primary diluent (air replaced by EGR) in the intake of a Hercules, 3.7 liter, lean-burn natural gas engine has been undertaken in this research. The Hercules engine was equipped with a General Motors electronically controlled EGR valve for low EGR rates, and a slide valve, constructed in house, for high EGR rates. Both valves were calibrated to quantify the EGR based upon pressures before and after the valves. The engine was mapped to find out the best possible combination of speed and load where replacement of excess air by EGR could be achieved. The combination of 2600 rpm and 70 ft-lb was found to be the best to achieve replacement. Replacement from a stock air-fuel equivalence ratio (lambda) of 1.32 till a stoichiometric lambda of 1.0 yielded favorable results. These replacement runs were not optimized for ignition timing and in consequence timing excursions were conducted for the replacement runs at lambda of 1.1, 1.2 and 1.32 and resulting emissions reported.
Recommended Content
Authors
Citation
Bhargava, S., Clark, N., and Hildebrand, M., "Exhaust Gas Recirculation in a Lean-Burn Natural Gas Engine," SAE Technical Paper 981395, 1998, https://doi.org/10.4271/981395.Also In
References
- Heywood, J.B. Internal Combustion Engine Fundamentals McGraw-Hill Inc. New York 1988
- Hundleby, G.E. “Low Emissions Approaches for Heavy-Duty Natural Gas-Powered Urban Vehicles,” SAE Paper 892134
- Weaver, C.S. “Natural Gas Vehicles- A Review of State of the Art,” SAE Paper 892133
- Weaver, C.S. Turner, S.H. “Dual Fuel Natural Gas/Diesel Engines: Technology, Performance and Emissions,” SAE Paper 940548
- L10 260/240G Engine Familiarization Information Brochure Cummins Engine Company, Inc. Columbus, IN 1994
- Nakagawa, K. Okamoto, K. Shoji, F. “Development of an Air/Fuel Ratio Control System for Lean-Burn Natural Gas Engines,” SAE Paper 942041
- Yasuhiro, Y. Higuchi, Y. Nagai, T. “NIGATA Ultra Lean-Burn SI Gas Engines- Achieving High Efficiency and Low NOx Emissions,” SAE Paper 901608
- Klimstra, J. “Performance of Lean-Burn Natural Gas-Fueled Engines- Specific Fuel Consumption, Power Capacity and Emissions,” SAE Paper 901495
- Arcoumanis, C. Bae, C.S. Xu, H.M. “Imaging of Lean Premixed Flames in Spark-Ignition Engines” SAE Paper 942052
- Horie, K. Nishizawa, K. Ogawa, T. Miura, K. “The Development of a High Fuel Economy and High Performance Four-Valve Lean-Burn Engine,” SAE Paper 920455
- Liss, W.E. Thrasher, W.H. “Natural Gas as a Stationary Engine and Vehicular Fuel,” SAE Paper 912364
- Clark, N,N, Mott, G.E. Atkinson, C.M. DeJong, R. Atkinson, R.J. Latvakoski, T. Traver, M.L. “Effect of Fuel Composition on the Operation of a Lean-Burn Natural Gas Engine,” SAE Paper 952560
- Kubesh, J. King, S. Liss, W.E. “Effect of Gas Composition on Octane Number of Natural Gas Fuels,” SAE Paper 922359
- Yamamoto, H. Horita, S. Matsuoka, T. “Surrounding Combustion Process (SCP)- New Concept for Lean-Burn Engine,” SAE Paper 920058
- DeJong, R. “An Investigation of Lean Combustion in a Spark-Ignited Natural Gas Engine,” West Virginia University 1996
- Whitelaw, J.H. Xu, H.M. “Cyclic Variations in a Lean-Burn Spark Ignition Engine Without and With Swirl,” SAE Paper 950683
- Traver, M.L. “An Analysis of In-Cylinder Pressure Histories in a Bi-Fuel Engine,” West Virginia University 1994
- Cole, J.J. “Development of the Hercules GTA 3.7L and 5.6L Engines for Low Emissions using an Open-Chamber Lean-Burn Combustion System,” SAE Paper 930927
- Avallone, E.A Baumeister Marks' Standard Handbook for Mechanical Engineers Ninth McGraw-Hill New York 1987
- Looney, K.B. “Exhaust Gas Recirculation as an Emissions Reduction Strategy in a Spark-Ignited Natural Gas Engine,” West Virginia University 1995
- Degobert, Paul Automobiles and Pollution Society of Automotive Engineers, Inc. Warrendale 1995
- Jaaskelainen, H.E. Wallace, W.S. “Examination of Charge Dilution with EGR to Reduce NOx Emissions from a Natural Gas-Fueled 16 Valve DOHC Four-Cylinder Engine,” SAE Paper 942006
- Ladammatos, N. Balian, R. Horrocks, R. Cooper, L. “The Effect of Exhaust Gas Recirculation on Combustion and NOx Emissions in a High-Speed Direct Injection Diesel Engine,” SAE Paper 960840
- Bhargava, S. “Exhaust Gas Recirculation in a Lean-Burn Natural Gas Engine,” West Virginia University 1997
- Latvakoski, T., E. “Detection, Analysis and Control of Knock in a Natural Gas, Lean-Burn Engine,” West Virginia University 1996
- Nine, R.D, Clark, N.N. Mace, B.E. El-Gazzar, L. “Hydrocarbon Speciation of a Lean-Burn Spark Ignited Engine,” SAE Paper 972971