This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Kinematic Modelling of a Constant Velocity Joint Using a Minimum Energy Method
Annotation ability available
Sector:
Language:
English
Abstract
An ideal constant velocity joint (ball-joint) would be a perfectly symmetric frictionless joint, with no clearance or interference between its perfectly rigid parts. Over the years, many kinematic models of such joints have been developed throughout the automotive industry, and they have supported important insights into the kinematic behavior and performance of ball-joints.
Such models are based on an analytic approach, whereby equations prescribing the motion of the parts are first derived and then solved. The realism or accuracy of the simulation produced by such a model depends upon the degree to which important physical effects can be captured by the formulation. The extent to which this can be achieved is ultimately limited by the ability to solve the resulting systems of highly non-linear equations.
This paper describes an alternative approach to kinematic ball-joint modelling avoiding this limitation. Based on a variational technique using elastic strain energy as the quantified parameter, the total system energy is minimized; a process equivalent to solving the equilibrium equations.
The method has been used to develop a three-dimensional kinematic model of a cross helical groove plunging ball-joint. The model handles the effects of geometric imperfections such as clearance or interference between the parts, and intermittent contact conditions. Hertzian Contact Theory is used to approximate the elastic compliance of the interaction between the balls and the ball grooves.
The model is efficient enough to perform many simulations within a reasonable time. It thus enables design sensitivity studies using data sets large enough to be statistically valid representations of real manufacturing variability.
The model has been used to predict backlash (lost motion) in manufactured joints. Comparison of these predictions with actual measurement shows very good correlation.
The practical advantages gained by using an energy method are discussed along with the feasibility of extending the model to include effects such as friction and structural deformation.
Recommended Content
Technical Paper | Constant Velocity Universal Ball Joints — Their Application in Wheel Drives |
Technical Paper | The Evolution of a Constant Velocity Universal Joint |
Technical Paper | Development of Test Rig for Model Analysis |
Authors
Citation
Norledge, M., "Kinematic Modelling of a Constant Velocity Joint Using a Minimum Energy Method," SAE Technical Paper 980832, 1998, https://doi.org/10.4271/980832.Also In
1998 Transmission and Driveline Systems Symposium: New Developments and Advanced Concepts in Systems and Components
Number: SP-1324; Published: 1998-02-13
Number: SP-1324; Published: 1998-02-13
References
- Wagner, E R Universal Joint and Driveshaft design Manual SAE Advances in Engineering
- Turina, G. 1995 VL-Joint Improvement. Analysis of Tolerance effects on the preload of assembled VL-Joint performed by a 2D-Model using MECHANICA software GKN Automotive AG R&D Center Lohmar, Germany
- Jain, P Agogino, A M Global Optimisation Using the Multistart Method
- Aarts, E Korst, J 1989 Simulated Annealing and Boltzmann Machines: A Stochastic Approach to Combinatorial Optimisation and Neural Computing Wiley New York
- NAg™ FORTRAN Library Manual - Mark 16 4
- Johnson, K L 1985 Contact Mechanics Cambridge University Press Cambridge
- Abramowitz, M Stegun, I 1970 Handbook of Mathematical Functions Dover Publications New York
- Rabinowitz, P. 1970 Numerical Methods for Nonlinear Algebraic Equations Gordon & Breach