This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Effect of Swirl and Fuel Injection Characteristics on Premixed Phase of Diesel Combustion
Annotation ability available
Sector:
Language:
English
Abstract
Fuel-air mixing during the early period has a significant influence on the combustion and emission processes of small diesel engines where combustion duration is short. The mixture heterogeneity during the premixed phase influences the premixed burnt fraction and the peak rate of energy release. The premixed burnt fraction is affected by engine speed, air swirl and fuel injection. In diesel engines, injection parameters, piston configuration and induction swirl interact with each other and have an optimum condition for a better performance. The present paper is an attempt to investigate these effects using an improved existing analytical model. The results concerning the effects of swirl and injection conditions on fuel-air mixing pattern, the premixed mass fraction and the rate of energy release at the instant of ignition, and duration of combustion on engine combustion and emission characteristics are presented.
Recommended Content
Authors
Topic
Citation
Mehta, P. and Tamma, B., "Effect of Swirl and Fuel Injection Characteristics on Premixed Phase of Diesel Combustion," SAE Technical Paper 980534, 1998, https://doi.org/10.4271/980534.Also In
References
- Kamimoto T. Aoyagi Y. Matsui Y. Matsuoka S. The Effects of Some Engine Variables on Measured Rates of Air Entrainment and Heat Release in a DI Diesel Engine SAE Transactions, Paper number 800253 1980
- Timoney David J. Effects of Important variables on Measured Heat Release Rates in a D.I. Diesel SAE Transactions, Paper number 870271 1987
- Van Gerpen J.H. Huang C. Borman G.L. The Effects of Swirl and Injection Parameters on Diesel Combustion and Heat Transfer SAE Transactions, Paper number 850265 1985
- Alkidas A.C. On the Premixed Combustion in a Direct-Injection Diesel Engine Trans ASME, Jl of Engineering for Gas Turbine and Power 109 1987 187 192
- Khan I.M. Greeves G. Wang C.H.T. Factors Affecting Smoke and Gaseous Emissions from Direct Injection Engines and a Method of Calculation SAE Transactions, Paper number 730169 1973
- Wiartalla A. Backer H. Durnholz M. Influence of Injection System Parameters on Spray Development Combustion and soot Formation by Optical Measurement Techniques in a Model Combustion chamber SAE Transactions, Paper number 950233 1995
- Mehta P.S. Gupta A.K. Gupta C.P. Model for Prediction of Incylinder and Exhaust Soot Emissions from Direct injection Diesel Engines SAE Transactions, Paper number 881251 1988
- Wade W.R. Hunter C.E. Trinker F.H. Cikanek H.A. Reduction of NO x and Particulate Emissions in the Diesel Combustion process Trans. ASME, Jl of Engineering for Gas Turbine and Power 109 1987 426 434
- Ohigashi S. Hamamoto Y. Tanabe S. Swirl- Its Measurement and Effect on Combustion in a Diesel Engine I. Mech E Conference on Air Pollution Control in Transport Engines 1971 129 136
- Mehta Pramod S Lahiri Debesh Bhaskar T. Evaluation of Role of Premixed Phase on Diesel Engine Combustion and Emission Characteristics Symposium on International Automotive Technology (SIAT'96) Pune,India 5-7 Dec SAE Paper number 962482 1996
- Wakuri Y. Ono S. Kido H. Takasaki K. An Experimental Study on the Exhaust Smoke of a Diesel Engine with Variable Angle Swirler Bull. JSME 24 193 1981 1198 1205
- Mehta P.S. Gupta A.K. Modelling of Spray-Swirl Interaction in Direct Injection Diesel Engine Combustion Chambers Proc. I. MechE 199 1985 187 197
- Mehta P.S. Singal S.K. Pundir B.P. A Comprehensive Simulation Model for Mixing and Combustion Characteristics of Small Direct Injection Diesel Engines Proc. I. MechE 209 1995 117 116
- Magnussen B.F. Hjertager B.H. On Mathematical Modeling of Turbulent Combustion with Special Emphasis on soot Formation and Combustion 16th Symposium (Intl.) on Combustion The Combustion Institute 1977 719 729
- Gosman A.D. Harvey P.S. Computer Analysis of Fuel-Air Mixing and Combustion in an Axi-Symmetric D.I. Diesel Engine SAE Transactions, Paper number 820036 1982
- Varnavas C.A. Assanis D.N. The Effects of Spray, Mixing and Combustion Model Parameters on KIVA -II Prediction SAE Transactions, Paper number 911785 1991
- Woschini G. Universally Applicable Equation for Instantaneous Heat Transfer Coefficient in the I.C. Engine SAE Transactions, Paper number 670431 1967
- Kamimoto T. Matsuoka S. Prediction of Spray Evaporation in Reciprocating Engines SAE Transactions, Paper number 770413 1977
- Chikahisa, T. Murayama T. Theory and Experiments on Air-Entrainment in Fuel Sprays and Their Application to Interpret Diesel Combustion Processes SAE Transactions, Paper number 950447 1995
- Bhaskar T. Mehta Pramod S Prediction of Turbulence in a Motored DI Diesel Engine Using a Quasi-Dimensional k-ε Model Proceedings of 1997 Spring Technology Conference ASME 1997 1997
- Monaghan M.L. Pettifer H.F. Air Motion and Its Effect on Diesel Performance and Emissions SAE Transactions, Paper number 810255 1981
- Tippelmann G. A New Method of Investigation of Swirl Ports SAE Transactions, Paper number 770404 1977
- Desantes J.M. Lapuerta M. Salavert J.M. Study on Independent effects of Diesel Engine Operating Conditions on Nitric Oxide Formation and Emissions Through Schematical Combustion Simulation Proc. I.MechE, Pt D: Jl of Automobile Engineering 210 1996 71 80
- Shundoh S. Kakegawa T. Tsujimura K. Kobayashi S. The Effect of Injection Parameters and Swirl on Diesel Combustion with High Pressure Fuel Injection SAE Transactions, Paper number 910489