This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Door Latch Strength in a Car Body Environment
Annotation ability available
Sector:
Language:
English
Abstract
Federal Motor Safety Standard (FMVSS) 206 regulates the minimum strength of side door latches in passenger carrying vehicles. The purpose of the standard's requirements is “to reduce the likelihood of occupants being ejected from vehicles in real world accidents.”
Investigation of unwanted door openings during accidents has revealed various types of latch failures that do not produce latch and/or striker damage consistent with that found in Federal Motor Vehicle Safety Standard compliance testing.
An intersection collision in which a striking vehicle contacts the struck vehicle aft of the affected door has for many years been considered the “most critical to door latch performance” (1). This type of car to car collision will often result in structural separation of the door end panel, “B” post striker panel or latch/striker assembly. These structural failures combine tensile and shear loading on the latch/striker assembly.
This paper defines the state of the industry with regard to vehicle door latch strength using a simple testing method that produces door latch separations more consistent with common intersection side impact collisions. The test methodology simultaneously applies both longitudinal and lateral loads as the vector sum of the FMVSS 206 defined loads. To place the test findings in perspective, results are normalized using the existing 206 requirements.
Recommended Content
Technical Paper | Door Latch Vulnerability to Rollover Induced Loads |
Technical Paper | Car Crash Tests of Ejection Reduction by Glass-Plastic Side Glazing |
Technical Paper | A Low Cost, High Performance Impact Test Facility |
Citation
Gilberg, A., Marcosky, J., Sherman, L., and Clarke, R., "Door Latch Strength in a Car Body Environment," SAE Technical Paper 980028, 1998, https://doi.org/10.4271/980028.Also In
References
- Gross, A. “Accidental Motorist Ejection and Door Latching Systems,” University of California Los Angeles SAE Paper No. 640165 SAE Transactions 73 1965
- Bartol, J. Wingenbach, W. Hodosy, F. “Performance Requirements for Doors, Door Retaining Devices and Adjacent Structures,” American Machine & Foundry Co. July 1969
- Letter from Robert A. Rogers - Director of Automotive Safety Engineering, General Motors (signed by Milford Bennett) to Kennerly H. Digges - Deputy Associate Administrator for Research and Development NHTSA November 3 1987
- Howe, G.J. Leigh, M. Willke, D.T. “Door Latch Integrity Study: Evaluation of Door Latch Failure Modes,” January 1994