This content is not included in your SAE MOBILUS subscription, or you are not logged in.
EGR Technologies for a Turbocharged and Intercooled Heavy-Duty Diesel Engine
ISSN: 0148-7191, e-ISSN: 2688-3627
Published February 24, 1997 by SAE International in United States
Annotation ability available
In this study three EGR methods were applied to a 12 liter turbocharged and intercooled Dl diesel engine, and the exhaust emission and fuel consumption characteristics were compared. One method is the Low Pressure Route system, in which the EGR is taken from down stream of the turbine to the compressor entrance. The other two systems are variations of the High Pressure Route system, in which the EGR is taken from the exhaust manifold to the intake manifold. One of the two High Pressure Route EGR systems is with back pressure valve located at downstream of the turbine and the other uses a variable geometry(VG) turbocharger. It was found that the High Pressure Route EGR system using VG turbocharger was the most effective and practical. With this method the EGR area could be enlarged and NOx reduced by 22% without increase in smoke or fuel consumption while maintaining an adequate excess air ratio.
CitationKohketsu, S., Mori, K., Sakai, K., and Hakozaki, T., "EGR Technologies for a Turbocharged and Intercooled Heavy-Duty Diesel Engine," SAE Technical Paper 970340, 1997, https://doi.org/10.4271/970340.
- Such C Needham J Edwards S Freeman H “Development of Heavy-Duty Diesel Engines for Low Emissions Using Exhaust Gas Recirculation (EGR)” 1995
- Havenith C Edwards S Such C Needham J “Development of a Heavy-Duty Diesel Engine towards EURO 3 Using Exhaust Gas Recirculation” EAEC 1995
- Baert R Beckman D Verbeek R “New EGR Technology Retains HD Diesel Economy with 21st Century Emissions” SAE Paper 960848 1996
- Uchida N Daisho Y Saito T Sugano H “Combined Effects of EGR and Supercharging on Diesel Combustion and Emissions” SAE Paper 930601 1993