This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Modeling Spray Impingement Considering Fuel Film Formation on the Wall
Annotation ability available
Sector:
Language:
English
Abstract
In this study, a new submodel concerning fuel film formation process is proposed in order to simulate the behavior of diesel spray impingement on relatively low temperature wall surface. Here, super - heating degree of the surface, defined by the temperature difference between the wall surface and the fuel saturated temperature, is newly considered for the behavior of impinged liquid droplets. In this spray impingement submodel, fuel film formation process, droplet interaction, film breakup process, and velocity and direction of dispersing droplets were considered based on several experimental results. This new submodel was incorporated into KIVA-II code, and the results were compared with experimental data KIVA-II original code and the spray / wall impingement model proposed by Naber & Reitz. As a result, it is found that the calculated results of impinging spray behavior by the new model agree well with experimental results.
Authors
Topic
Citation
Senda, J., Kanda, T., Al-Roub, M., Farrell, P. et al., "Modeling Spray Impingement Considering Fuel Film Formation on the Wall," SAE Technical Paper 970047, 1997, https://doi.org/10.4271/970047.Also In
References
- Fujimoto, H. Saito, M. Minoura, A. Katsura, N. Cho, I. Y. Senda, J. “Characteristics of a Diesel Spray Impinging on a Flat Wall” 439 446 1988
- Katsura, N. Saito, M. Senda, J. Fujimoto, H. “Characteristics of a Diesel Spray Impinging on a Flat Wall” SAE Trans. 98 890264 191 207 1989
- Fujimoto, H. Senda, J. Nagae, M. Hashimoto, A. “Characteristics of a Diesel Spray Impinging on a Flat Wall” Int. Sympo. COMODIA 90 193 198 1990
- Senda, J. Fukami, Y. Tanabe, Y. Fujimoto, H. “Visualization of Evaporative Diesel Spray Impinging upon Wall Surface by Exciplex Fluorescence Method” SAE Trans. 101 920578 1 10 1992
- Senda, J. Tanabe, Y. Fujimoto, H. “Visualization and Quantitative Analysis on Fuel Vapor Concentration in Diesel Spray” Advanced Study Institute on Unsteady Combustion II 27.1 27.6 1993
- Amsden, A.A. Ramshaw, J.D. O'Rourke, P.J. Dukowicz, J.K. “KIVA: A Computer Program for Two - and Three - Dimensional Fluid Flow with Chemical Reactions and Fuel Sprays” Los-Alamos National Laboratory report 1985
- Naber, J.D. Reitz, R.D. “Modeling Engine Spray / Wall Impingement” SAE paper, No.881316 1 23 1988
- Senda, J. Kobayashi, M. Iwashita, S. Fujimoto, H. “Modeling on Diesel Spray Impinging on Flat Wall” COMODIA 94 411 416 1994
- Senda, J. Kobayashi, M. Iwashita, S. Fujimoto, H. “Modeling of Diesel Spray Impingement on a Flat Wall” SAE paper, No. 941894 1 14 1994
- Senda, J. Takeuchi, K. Sato, Y. “Experimental Studies on the Behavior of a Small Droplet Impinging upon a Hot Surface” 14-4 397 404 1982
- Senda, J. Takeuchi, K. Sato, Y. “Atomization of Spray Droplet Impinging upon a Hot Surface” Internal Combustion Engine 21-268 9 18 1982
- Senda, J. Yamada, K. Takeuchi, K. Miki, H. “Deformation and Breakup Behavior of a Small Droplet Impinging upon a Hot Surface” Trans. Of JSME 52-481 3372 379 1986
- Senda, J. Yamada, K. Fujimoto, H. Miki, H. “The Heat - Transfer Characteristics of a Small Droplet Impinging upon a Hot Surface” JSME Int. Journal 3 1 105 111 1988
- Kurabayashi, T. Karasawa, T. Iida, K. JSME 175 153 156 1967
- Al-Roub, M.A. Farrell, P.V. Senda, J. “Near Wall Interaction in Spray Impingement” SAE paper, No. 960863 171 131 1996
- Al-Roub, M.A. “Hydrodynamics and Heat Transfer of Multiple Droplet Impingement” Univ. of Wisconsin-Madison 1995
- Wachters, L.H.J. Westerling, N.A.J. “The Heat Transfer from a Hot Wall to Impinging Water Drops in the Spheroidal State” Chem. Eng. Sic. 21 1047 1057 1966
- Watkins, A.P. Wang, D.M. “A new model for diesel spray impaction on walls and comparison with experiment” COMODIA-90 243 248 1990
- Wang, D.M. Watkins, A.P. “Numerical modeling of diesel spray wall impaction phenomena” Int. J. Heat and Fluid Flow 14-3 301 312 1993
- O'Rourke, P.J. Bracco, F.V. “Modeling of drop interactions in thick sprays and a comparison with experiment” In Stratified Change Automotive Engines conf. I Mech.E. London 1980
- Wakisaka, T. Shimamoto, Y. Isshiki, Y. Noda, T. Matsui, A. Akamatsu, S. “Numerical Analysis of Spray Phenomena in Fuel Injection Engines” COMODIA-94 403 409 1994
- Nagaoka, M. Kawazoe, H. Nomura, N. “Modeling Fuel Spray Impingement on a Hot Wall for Gasoline Engines” SAE paper, No. 940525 1994
- Naitoh, K. Takagi, Y. Kokita, H. Kuwabara, K. “Numerical Prediction of Fuel Secondary Atomization Behavior in SI Engine based on the Oval-Parabola Trajectories (OPT) Model” SAE Paper, No. 940526 1994
- Bai, C. Gosman, A.D. “Development of Methodology for Spray Impingement Simulation” SAE Paper, No. 950283 1995
- Eckhause, J.E. Reitz, R.D. “Modeling Heat Transfer to Impingement Fuel Sprays in Direct-Injection Engines” Atomization and Sprays 5 213 242 1995
- Bai, C. Gosman, A.D. “Mathematical Modeling of Wall Films Formed by Impinging Sprays” SAE Paper, No. 960626 1996
- Ahmadi-Befrui, B. Uchil, N. Gosman, A.D. Issa, R.I. “Modeling and Simulation of Thin Liquid Films Formed by Spray-Wall Interaction” SAE Paper, No. 960627 1996
- Stanton, P.W. Rutland, C. “Modeling Fuel Film Formation and Wall Interaction in Diesel Engines” SAE Paper, No. 960628 1996
- Furuhama, S. Suzuki, H. “Temperature Distribution of Piston Rings and Piston in High Speed Diesel Engine” Bull. JSME 22 174 1788 1795 1979
- Murayama, T. “Wall Temperature for I.D.I Engine” Trans. of JSME 35-274 1310 1969
- Hiroyasu, H. Kadota, T. Senda, T. “Droplet Evaporation on a Hot Surface in Pressurized and Heated Ambient Gas” Trans. of JSME 39-328 3779 1973
- Tamura Tanasawa, Y. “Evaporation and Combustion of a Drop Contacting with a Hot Surface” 7th Int.Comb.Sympo. 124 509 522 1958
- Naber, J.D. Farrell, P.V. “Hydrodynamics of Droplet Impingement on a Heated Surface” SAE Paper, No. 930919 1993
- Coghe, A. Cossali, G.E. Marengo, M. “A First Study about Single Drop Impingement on Thin Liquid Film in a Low Laplace Number Range” 11th European Conf. of ILASS-Europe 285 293 1995
- Mundo, C.H.R. Sommerfeld, M. Tropea, C. “Droplet - Wall Collisions: Experimental Studies of the Deformation and Breakup Process” Int.J.Multi Phase Flow 21-2 151 173 1995
- Marengo, M. “Analisi Dell'impatto di Gocce su Film Liquido Sottile” Univ. of Erlangen- Noremberg 1995
- Yarin, A.L. Weiss, D.A. “Impact of drops on solid surfaces: self-similar capillary waves, and splashing as a new type of kinematic discontinuity” J.Fluid Mech. 283 141 173 1995