This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
A Contribution in Calculating the Thermal Fields in Internal Combustion Engines Components
Annotation ability available
Sector:
Language:
English
Abstract
In literature, particular interest is directed toward procedures allowing for accurate predictions of thermal fields in Internal Combustion Engines (ICE) components facing gases. While the calculation of the steady part is straightforward, the evaluation of the unsteady temperatures is complex, time consuming and still calls for further refinement. The possibility of obtaining these predictions only in single portions of the components (without solving the whole thermal field, but keeping the same accuracy), reveals an even greater interest.
In this paper a suggestion for reaching this goal is given. It is based on isolating a portion of the component on which a suitably defined steady calculation were firstly performed. This gives the initial condition for an unsteady calculation performed only over this portion: precise results in terms of instantaneous temperatures and heat fluxes are obtained in comparison with a traditional method based on the solution of the unsteady thermal problem on the whole component.
Citation
Anatone, M. and Cipollone, R., "A Contribution in Calculating the Thermal Fields in Internal Combustion Engines Components," SAE Technical Paper 961127, 1996, https://doi.org/10.4271/961127.Also In
References
- Morel T. et al. “Cyclical thermal phenomena in engine combustion chamber surfaces” SAE Paper 850360 1985
- Cipollone R. D'Amato E. “Influenza delle condizioni di vincolo sulle deformazioni di natura termica nelle canne di MCI” ATA Ingegneria automobilistica n 12 december 1989
- Woschni G. Spindler W “Heat transfer with insulated combustion chamber walls and its influence on performance of diesel engines” Journal of Engineering for Gas Turbines and Power Vol. 110 july 1988
- Kornhouser A. A. Smith J. L. “Application of a complex Nusselt number to heat transfer during compression and expansion” Journal of Heat Tranfer Vol. 116 august 1994
- Sutor P. Bryzik W “Tribological systems for high temperature diesel engines” SAE Paper 870157 1987
- Sutor R Bryzik W “Development of advanced high temperature liquid lubricant” SAE Paper 880015 1988
- Cheng S. S. Kim C. “Effect of engine operating parameters on engine combustion chamber deposits” SAE Paper 902108 1990
- Nakic D. J. Assanis D. N. White R. A. “Effect of elevated piston temperature on combustion chamber deposit growth” SAE Paper 940948 1994
- Kamo R, Bryzik W. Glance, P. “Adiabatic engine trends worldwide” SAE Paper 870018 1987
- Wong V. W. “MIT Research Consortium on the use of ceramics in internal combustion engines” october 1986
- Siegla D. C. Amann C. A. “Exploratory study of the low heat rejection diesel for passenger car application” SAE Trans. Vol. 93 1984
- Assanis D. N. Badillo E. “Transient analysis of piston-liner heat transfer in a low heat rejection diesel engine” SAE Paper 880189 1988
- Carslaw H. S. Jaeger J. C. Conduction of heat in solids Oxford Press 1959
- Kruggel O. “Calculation and measuring of piston temperatures of air-cooled two-stroke gasoline engines” SAE Paper 710578 1971
- Bignardi L. Cipollone R. “Contributo allo studio dei campi termici non stazionari nelle canne-cilindro di M.C.I. ” 42° Congresso Nazionale A.T.I. Genova-Italy 8-12 settembre 1987
- Shih T. M. Numerical heat transfer Hemisphere Publ. Co. 1984
- Boisclair M. E. Hoult D. P Wong V. W. “Piston ring thermal transient effects on lubricant temperatures in advanced engines” Journ. of Eng. for Gas Turbines and Power vol. 111 july 1989
- Cipollone R. D'Amato E. “On the evaluation of the periodic thermal state in ICE components” 7th Inernational Conference on Numerical Methods in Thermal Problems Stanford, USA july 8-12 1991
- Morel T. et al. “Methods for heat transfer and temperature field analysis of the insulated diesel. Part I & II” Report DOE/NASA 0342-1, 0342-2 1984-1985
- Wakuri Y. Soejima M. Yamamoto T. Ootsubo M. “Fundamental studies on scuffing between cylinder and piston ring” JSAE Review Vol. 7 No. 2 1986
- Bignardi L. Cipollone R. “An improvement in calculating the thermal fields in the piston-cylinder system” Heat Transfer in Radiating and Combusting Systems, Eurotherm Seminar No. 17 Cascais october 8-10 1990
- Rasihhan Y. Wallace F. J. “Temperature transients on engine combustion chamber walls -III. Application of the finite difference model to the various metal and ceramic walls” Int. Journal of mechanical Sciences vol. 33 No. 11 863 874 1991
- Eichelberg G. “Some new investigations on old combustion engine problems” Engineering acts 27 1939
- Morel T. Keribar R. “Warmup characteristics of a spark ignition engine as a function of speed and load” SAE Paper 900683 1990
- Bignardi L. Cipollone R. Padova 27-29 sett. 1990
- Bignardi L. Cipollone R. “Unsteady heat transfer in Internal Combustion Engines” Heat Transfer in Internal Combustion Engines, Eurotherm Seminar n. 15 Toulose, France 1991
- Cipollone R. “On the solution of unsteady heat transfer problems in ICE” SAE Paper 931984 1993
- Anatone M. “A procedure for calculating the unsteady thermal fields in internal combustion engines” XII National Congress on Heat Transfer - Italian Union of Thermofluidynamics L'Aquila, Italy june 23th-24th 1994