This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
System Identification by Characteristic Matrices Using the Modal Parameters (An Application to Automotive's Subframe)
Annotation ability available
Sector:
Language:
English
Abstract
This paper presents some considerations and an application to automotive's subframe concerning system identification method by characteristic matrices using modal parameters to obtain rigid-body properties of mechanical structure. The pendulum method was adopted as the conventional way to identify the rigid-body properties in automotive's engine components such as flywheel. In the case of the big, complex shaped and heavy structural component such as frame and vehicle body, this method is not adequate for the difficulty of building the huge fixture and making sure of the accuracy of identification. So, in this paper, the method identifying characteristic matrices using the modal parameters is applied to automotive's subframe.
Recommended Content
| Technical Paper | A New Tooth Flank Form to Reduce Transmission Error of Helical Gear |
| Technical Paper | Casting Cylinders in Green Sand |
| Technical Paper | PRACTICAL BALANCING OF A V-TYPE ENGINE CRANKSHAFT
|
Authors
Citation
Nakamura, M., Sawanobori, T., Nagamatsu, A., Kamada, Y. et al., "System Identification by Characteristic Matrices Using the Modal Parameters (An Application to Automotive's Subframe)," SAE Technical Paper 951362, 1995, https://doi.org/10.4271/951362.Also In
References
- Nagamatsu, A. “Modal Analysis” Baifu-kan 307 Tokyo, Japan 1985
- Nagamatsu, A. et al. “Substructure Synthesis Method” Baifukan 91 Tokyo 1991
- Japan Society of Mechanical Engineers “Fundamentals of Modal Analysis and Its Application” Maruzen 103 Tokyo 1986
- Potter, R. W. Richardson, M. “Mass, Stiffness, and Damping Matrices from Measured Modal Parameter” Instrument Society of America New York 1974
- Taniguchi, O. et al. “Vibration Engineering Hand-book” Youken-do 821 Tokyo 1976
- Ewins, D.J. “Modal Testing: Theory and Practice” Research Studies Press Ltd. 269 London 1984
- Butsuen, T. et al. “Application of Direct System Identification Method for Engine Rigid Body Mount System” SAE paper, No. 860551 1986
- Weui, Bong Jeong et al. “Experimental Identification of a Mechanical Structure with Characteristic Matrices” Trans. of JSME 2077 Tokyo 1988
- Okuma, M. et al. “Experimental Identification of a Mechanical Structure with Characteristic Matrices” Trans. of JSME 2557 Tokyo 1988