This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
A Simple Modeling for Analyzing the Load Distribution of Toothed Belts Under Fluctuating Torque Loading
Annotation ability available
Sector:
Language:
English
Abstract
It is very important to know the load distribution in pulleys to predict the life of toothed belts. In this study, a simple model consists of springs and friction elements has been developed for numerical analysis of the load distribution.
A sample problem with steady pulley motion for a two pulley system was analyzed. The analytical result was compared with the experimental result. It was also compared with the numerical result by the alternative model using FEM. Relatively good agreements between them were obtained. A typical problem for the two pulley system subjected to fluctuating torque loadings was also analyzed by the present model. The calculated result shows a large difference in tooth load distribution between the steady state case and the unsteady state one.
Recommended Content
Authors
Citation
Shimizu, K. and Fujii, T., "A Simple Modeling for Analyzing the Load Distribution of Toothed Belts Under Fluctuating Torque Loading," SAE Technical Paper 950542, 1995, https://doi.org/10.4271/950542.Also In
Applications and Developments in New Engine Design and Components
Number: SP-1071; Published: 1995-02-01
Number: SP-1071; Published: 1995-02-01
References
- Amijima S. Fujii T. On Tooth load distribution of synchronous belts J. of JSME 42 359 1976 2233 2241
- Gerbert G. et al. Load distribution in timing belts Trans. ASME J. Mech. Design 100 1978 208 215
- Koyama T. et al. A study on strength of toothed belts: 2nd report Bull. JSME 22 1979 982 987
- Kido R. et al. A Finite Element Analysis For Frictional Force Power Transmission of Flat Belts Proc. of JSAE 892192 1989 435 438
- Kido R. et al. A New Approach for Analyzing Load Distribution of Toothed Belts at Steady States Using FEM SAE Tech. Paper Series, 940690 1994
- Firbank T. C. On the forces between the belt and driving pulley of a flat belt drive ASME Design Tech. Conf. Paper, 77 - DET - 161
- Uchida T. et al. The Analysis of a Load on Each Tooth of 4 Cycle Gasoline Engine's Cam Pulley Proc. of MPY '91 1991