This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
A Performance Study of Iso-Butanol-, Methanol-, and Ethanol-Gasoline Blends Using a Single Cylinder Engine
Annotation ability available
Sector:
Language:
English
Abstract
The objective of this study was to evaluate iso-butanol (C4H9OH) as an alternative fuel for spark ignition engines. Unlike methanol (CH3OH) and ethanol (C2H5OH), iso-butanol has not been extensively studied in the past as either a fuel blend candidate with gasoline or straight fuel. The performance of a single cylinder engine (ASTM=CFR) was studied using alcohol-gasoline blends under different input parameters. The engine operating conditions were: three carburetor settings (three different fuel flow rates), spark timings of 5°, 10°, 15°, 20°, and 25° BTDC, and a range of compression ratios from a minimum of 7.5 to a maximum of 15 in steps of one depending on knock. The fuels tested were alcohol-gasoline blends having 5%, 10%, 15%, and 20% of iso-butanol, ethanol, and methanol. And also as a baseline fuel, pure gasoline (93 ON) was used. The engine was run at a constant speed of 800 RPM. Torque, power, brake specific fuel consumption (BSFC), and thermal efficiency were determined at all the operating conditions. A direct comparison was drawn among the three alcohol blends and pure gasoline.
Increasing alcohol content of the blend resulted in improving the anti-knock quality of the fuel but decreasing the power, and increasing BSFC. Thermal efficiency remained comparably constant within the range of fuel alcohol contents (5-20%). Methanol, ethanol, and iso-butanol showed nearly the same anti-knock effect. Iso-butanol blends resulted in more power, higher thermal efficiency, and lower BSFC than corresponding methanol and ethanol blends. Gasoline showed better results for torque, power, BSFC, and thermal efficiency than any of the blends studied.
Recommended Content
Topic
Citation
Popuri, S. and Bata, R., "A Performance Study of Iso-Butanol-, Methanol-, and Ethanol-Gasoline Blends Using a Single Cylinder Engine," SAE Technical Paper 932953, 1993, https://doi.org/10.4271/932953.Also In
References
- Alternate Fuels Committee of the Engine Manufacturers Association “ A Technical Assessment of Alcohol Fuels ” International Congress and Exposition Detroit, Michigan February 22 26 1982 SAE paper no. 820261
- American Society for Testing and Materials “ Annual Book of ASTM Standards - Test Methods for Rating Motor,Diesel, and Aviation Fuels” 1981
- Bata R. M. et al. “Emissions from IC Engines Fueled with Alcohol-Gasoline Blends: A Literature Review” Engine Emissions, Journal of Engineering for Gas Turbines and Power 111 424 1989
- Bata R. M. et al. “Butanol as a Blending Agent with Gasoline for I. C. Engines” International Congress and Exposition Detroit, Michigan February 27 March 3 1989 SAE paper no. 890434
- Bernstein L. S. et al. “Performance Evaluation of 10% Ethanol-Gasoline Blends in 1980 Model Year U.S. Cars” SAE paper no. 821185
- Bosch Group “Automotive Hand Book” 2nd 0-89883-518-6 1989
- Brinkman N. D. et al. “Exhaust Emissions, Fuel Economy, and Driveabiliry of Vehicles Fueled with Alcohol-Gasoline Blends” Automotive Engineering Congress and Exposition Detroit, Michigan February 24 28 1975 SAE paper no. 750120
- Brinkman N. D. “Ethanol Fuel - A Single Cylinder Engine Study of Efficiency and Exhaust Emissions” International Congress and Exposition Cobo Hall, Detroit, Michigan February 23 27 1981 SAE paper no. 810345
- First Interim Report of the Interagency Commission on Alternative Motor Fuels September 30 1990
- Furey R. L. et al. “Emissions, Fuel Economy, and Driveability Effects of Methanol/Butanol/Gasoline Fuel Blends” SAE paper no. 821188
- Hagen D. L. “Methanol as a Fuel: A Review with Bibliography” Passenger Car Meeting Detroit, Michigan September 1977 SAE paper no. 770792
- Heywood J. B. “Internal Combustion Engine Fundamentals” McGraw-Hill Book Company 1988
- Johnson R. T. et al. “Single Cylinder Spark Ignition Engine Study of the Octane, Emissions and Fuel Economy Characteristics of Methanol-Gasoline Blends” Detroit Congress Detroit, Michigan February 23 27 1976 SAE paper no. 760377
- Kirk Othmer “Encyclopedia of Chemical Technology - Butyl Alcohols” 4 Third John Wiley and Sons Publication 1986
- Kohl W. L. “Methanol as an Alternative Fuel Choice: An Assessment” The John Hopkins Foreign Policy Institute Publication 1990
- Kothandaraman C. P. et al. “Heat and Mass Transfer Data Book” Third Wiley Eastern Limited Publication 1987
- Kretschmer D. et al. “Alcohols as Additives to Gasoline Combustion Tests in a Single Cylinder Engine” Energy Sources Technology Conference and Exhibition Dallas, Texas February 15 20 1987 ASME Publication 1987
- Lee R. C. “Effect of Compression Ratio, Mixture Strength, Spark Timing, and Coolant Temperature Upon Exhaust Emissions and Power” National Combined Fuels and Lubricants, Powerplant and Truck Meetings St. Louis, Missouri October 26 29 1971 SAE paper no. 710832
- Minkoff Tipper “ Chemistry of Combustion Reactions ” 1987
- Obert E. F. “ Internal Combustion Engines and Air Pollution ” Third Harper and Row Publication 1973
- Owen K. “ Automotive Fuels Handbook ” SAE Publication 1990
- Radwan M. S. “ Performance and Knock Limits of Ethanol-Gasoline Blends in Spark Ignited Engines ” International Congress and Exposition Detroit, Michigan February 25 March 1 1985 SAE paper no. 850213
- Rice R. W. et al. “ Exhaust Gas Emissions of Butanol, Ethanol, and Methanol-Gasoline Blends ” Energy Sources Technology Conference and Exhibition Houston, Texas January 20 23 1991 ASME Publication
- Saeed M. N. Henein N “ Combustion Phenomena of Alcohols in CI Engines ” Journal of Engineering for Gas Turbines and Power 111 July 1989
- Taylor C. F. “ The Internal Combustion Engine in Theory and Practice ” I II Second The M. I. T Press 1990