This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Plane-Strain Tension Tests of Al 2008-T4 Sheets
Annotation ability available
Sector:
Language:
English
Abstract
Rectangular aluminum sheets were stretched under in-plane plane-strain tension using a simple experimental setup. The samples can be stretched under these conditions until localized necking occurs at the centerline. The strain distributions and the loads were recorded at different strain levels. Good agreement was found between actual loads and those calculated from strain measurements assuming isotropic hardening with a high exponent yield criterion.
Recommended Content
| Technical Paper | Warm Forming the GM V-6 Oil Pan in Aluminum |
| Aerospace Material Specification | Silver Alloy, Brazing Filler Metal 56Ag - 22Cu - 17Zn - 5.0Sn 1145 to 1205 °F (618 to 652 °C) Solidus-Liquidus Range |
Authors
Citation
Graf, A. and Hosford, W., "Plane-Strain Tension Tests of Al 2008-T4 Sheets," SAE Technical Paper 930812, 1993, https://doi.org/10.4271/930812.Also In
References
- Wilson D. V. Int. Mat. Rev. 1990 35 6 329 347
- Barlat F. Mat. Sci. and Eng. 1987 91 55 72
- Graf A. Hosford W. Met. Trans. 1990 21A 87 94
- Logan R. Meuleman D. Hosford W. Formability and Metallurgical Structure Sachdev A. K. Embury J. D. TMS-AIME Warrendale, Pa. 1987 159 73
- Wagoner R. H. Met. Trans. 1980 11A 165 75
- Wagoner R. H. Wang N. M. Int. J. Mech. Sci. 21 255 64
- Hosford W. F. 7 th North American Melalworking Research Conference Proceedings SME Dearborn, MI 1979 191
- Hill R. Proc. Roy. Soc. 1949 198 428