This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Effects of Flame Motion and Temperature on Local Wall Heat Transfer in a Rapid Compression-Expansion Machine Simulating Diesel Combustion
Annotation ability available
Sector:
Language:
English
Abstract
Local heat flux from the flame to the combustion chamber wall, q̇, was measured the wall surfaces of a rapid compression-expansion machine which can simulate diesel combustion. Temperature of the flame zone, T1, was calculated by a thermodynamic two-zone model using measured values of cylinder pressure and flame volume. A local heat transfer coefficient was proposed which is defined as q̇/(T1-Tw). Experiments showed that the local heat transfer coefficient depends slightly on the temperature difference, T1-Tw, but depends significantly on the velocity of the flame which contacts the wall surface.
Recommended Content
Authors
Topic
Citation
Kamimoto, T., Kobori, S., Noh, S., and Enomoto, Y., "Effects of Flame Motion and Temperature on Local Wall Heat Transfer in a Rapid Compression-Expansion Machine Simulating Diesel Combustion," SAE Technical Paper 922208, 1992, https://doi.org/10.4271/922208.Also In
References
- Furuhama S. Enomoto Y. “Heat Transfer into Ceramic Combustion Wall of Internal Combustion Engines,” SAE 870153
- Huang J. C. Borman G. L. “Measurements of Instantaneous Heat Flux to Metal and Ceramic surfaces in a Diesel Engine” SAE 870155
- Woschni G. Spindler W. “Heat Transfer With Insulated Combustion Chamber Walls and Its Influence on the Performance of Diesel Engines” Trans. ASME 110 482 1988
- Assanis D. N. et al. “A Prototype Thin-Film Thermocouple for Transient Heat Transfer Measurements in Ceramic-Coated Combustion Chambers” SAE 900691
- Jennings M. J. Morel T. “A Computational Study of Wall Temperature Effects on Engine Heat Transfer” SAE 910459
- Nishiwaki K. Hagiwara T. “The Potential of Heat Transfer Control on Insulated Combustion Chamber Walls” International Sympo. COMODIA 90 1990
- Morel T. Keribar R. “A Model for Predicting Spatially and Time Resolved Convective Heat transfer in Bowl-in-Piston Combustion Chambers” SAE 850204
- More T. Wahiduzzaman S. Fort E. F. “Heat Transfer Experiments in an Insulated Diesel” SAE 880186
- Morel T. et al. “Heat Transfer in a Cooled and an Insulated Diesel Engine” SAE 890572
- Hansen A. C. “A Diagnostic Quasi-Dimensional Model of Heat Transfer Applied to a Motored Compression-Ignition Engine” SAE 920542
- Kamimoto T. et al. “Convective Heat Transfer of an Impinging Diesel Flame in a Rapid Compression Machine” SAE 821035
- Matsui Y. Kamimoto T. Matsuoka S. “A Study on the Time and Space Resolved Measurement of Flame Temperature and Soot Concentration in a D.I. Diesel Engine by the Two-Color Method” SAE 790491