This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Experiences with Electrically Heated Catalysts
ISSN: 0148-7191, e-ISSN: 2688-3627
Published October 01, 1991 by SAE International in United States
Annotation ability available
Increasing pressure on lowering vehicle emissions to meet stringent California and Federal 1993/1994 emission standards (TLEV) of 0.125 gpm NMOG, 3.4 gpm CO and 0.4 gpm NOx and future ULEV emission standards of 0.04 gpm NMOG, 1.7 gpm CO, and 0.2 gpm NOx has focused specific attention on the cold start characteristics of the vehicle's emission system, especially that of the catalyst. From test data it is evident that the major portion of the total HC and CO emissions occur within the first two minutes of the driving cycle. The use of an electrically heated catalyst (EHC) is shown to be advantageous in lowering cold-start emissions during this portion of the drive cycle. This paper addresses the effect on emissions from the standpoint of EHC location, catalyst volume, and engine calibration in an overall emission system approach. Results indicate that locating the EHC downstream of the front TWC provides a level of protection for the mini-EHC without a loss in exhaust gas aftertreatment capability. Further, engine calibration and catalyst volume coupled with an EHC show that these optimization factors can contribute to meeting ULEV standards. However, these emission improvements have been at a premium, i.e. lower fuel economy, additional vehicle weight, power consumption, and yet to be totally accessed EHC durability.
CitationHurley, R., Guttridge, D., Hansen, L., Pawlowicz, R. et al., "Experiences with Electrically Heated Catalysts," SAE Technical Paper 912384, 1991, https://doi.org/10.4271/912384.
- Whittenberger, W. A. and Kubsh J. E., “Electrically Heated Metal Substrate Durability”, SAE paper Number 910613, 1991.
- Hurley, R. G., Hansen L. A., LaCourse D. L., Watkins W. L. H., Gandhi H. S., and Whittenberger W. A.,“Evaluation of Metallic and Electrically Heated Metallic Catalysts on a Gasoline Fueled Vehicle”, SAE Paper Number 900504, 1990.
- Heimrich, M. J., Albu S., and Osborne J., “Electrically-Heated Catalyst System Conversions on Two Current-Technology Vehicles”, SAE Paper Number 910612, 1991.
- Heimrich, M. J., “Air Injection to an Electrically-Heated Catalyst for Reducing Cold-Start Benzene Emissions from Gasoline Vehicles”, SAE Paper Number 902115, 1990.
- Schwarz, M. J., and Schiller J. W., “Clean Air Act Amendments of 1990, Impact on Motor Vehicles and the Environment”, Presented at 84th Annual Meeting of the Air & Waste Management Association, 1991.
- Gottberg, I., Rydquist J. E., Backlund O., Wallman S., Maus W., Bruck R., and Swars H., “New Potential Exhaust Gas Aftertreatment Technologies for Clean Car Legislation”, SAE Paper Number 910840, 1991.