This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Leak Detection of the Space Station Freedom U.S. Lab Vacuum System Using Reverse Flow Leak Detection Methodology
Annotation ability available
Sector:
Language:
English
Abstract
A vacuum system leak detection technique (Reverse Flow Leak Detection) under development at Teledyne Brown Engineering in Huntsville, AL. for use aboard Space Station Freedom is presented. The technique will be applied to the Vacuum System (VS) and Waste Gas Management Subsystem (WGMS) of the U.S. Lab Module. These two systems contain over 45.7 m. of distributed vacuum tubing located in remote utility runs. Fluid flow calculations which utilize known system geometry and measured steady state pressure measurements from the VS and WGMS can be used to identify leak sites within ±38 cm. Exact leak position can then be pinpointed by conventional tracer gas leak detection in the identified region. Tests have been performed using a simple, unrestricted 12.8 m length of vacuum tubing with a calibrated air leak attached. The 12.8 m tube is alternately evacuated by cryopumps on either end. Steady-state pressure measurements taken before and after flow reversal in the system have been used to locate leaks accurately.
Authors
Citation
Moore, J., Shepherd, J., and Masden, D., "Leak Detection of the Space Station Freedom U.S. Lab Vacuum System Using Reverse Flow Leak Detection Methodology," SAE Technical Paper 911456, 1991, https://doi.org/10.4271/911456.Also In
References
- Santeler TBE Report SS88-SE-0100 1989
- Santeler TBE Report SS88-SE-0101 1989
- Masden Moore Cole TBE Report SS88-PLAN-0127 1990
- Jitschin W. J. Vac. Sci Technol. A8 948 1990
- Lange Singleton Eriksen J. Vac. Sci Technol. 3 338 1966
- Peacock Peacock 1990
- O'Hanlon A User's Guide to Vacuum Technology Wiley-Interscience New York 1980