This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
A Variable Timing Electonically Controlled High Pressure Injection System for 2T S.I. Engines
Annotation ability available
Sector:
Language:
English
Abstract
Following general remarks about high pressure direct injection systems impact on two stroke S.I. engine applications, further advantages, both on emissions as well as fuel consumption, obtainable with a variable timing injection system are presented.
An exhaustive evaluation, carried out on a single cylinder air cooled engine, clearly shows that sensible reductions, basically in HC emissions as well as in fuel consumptions can be obtained delaying the injection beginning depending on RPM and engine load. Further advantages appear available at idle, injecting every other cycle, if a suitably conceived system is adopted.
Finally an electronically controlled high Pressure injection system, derived from a low cost and dependable solution for small engines is proposed.
Recommended Content
Technical Paper | Performance Development of the Supercharged Mercury Marine Outboard Engines |
Technical Paper | Direct Injection of Fuel Mixture in a Spark Ignition Two-Stroke Engine |
Technical Paper | Further Research on Charge Stratification |
Authors
Citation
Nuti, M., "A Variable Timing Electonically Controlled High Pressure Injection System for 2T S.I. Engines," SAE Technical Paper 900799, 1990, https://doi.org/10.4271/900799.Also In
References
- Douglas R. et al “Fuel Injection of on Two Stroke Cycle Spark ignition engine” SAE PAPER 820952
- Nuti M. “Direct Fuel injection: An opportunity for two-stroke SI Engines in Road Vehicle use” SAE PAPER 860170
- Kato T. et al “Gasoline Direct Injection for a Loop-Scavenged two stroke cycle Engine” SAE PAPER 871690
- Göschel K.H. “Die Daimler-Benz Benzin-Einspritzung” MTZ 1 1959
- Witzky J.E. “Benzin Einspritzung in USA” MTZ 1 1959
- Jalbert J. “Economie de combustible dans l'emploi des moteurs a allumage commande” Journal SIA July 1953
- Duret P. et al “A new Two-Stroke Engine with Compressed Air Assisted fuel injection for high Efficiency Low Emissions Application” SAE PAPER 880176
- Automotive Engineer Dec 1986 “Focus on petrol injection and carburation”
- Williams D. “Orbital's Coming Says Walbro” Automotive Industries May 1987
- Nuti M. “Direct Fuel Injection: Piaggio Approach to Small 2T SI Engines” SAE PAPER 880172
- Kollman R.E. et al “Exhaust Emission Characteristics of a Small 2 - Stroke Cycle Spark ignition engine” SAE PAPER 730159
- Nuti M. “Optimization of engine emissions and fuel consumption with engine mapping method” XXXVI ATI Congress 1981
- Seilly A.H. “Helenoid Actuators - A new concept in extremely fast acting solenoids” SAE PAPER 790119
- Seilly A.H. “Colenoid Actuators - Further developments in extremely fast acting Solenoids” SAE PAPER 810462
- Schechter M.M. “Fast Response muLtiple solenoids” SAE PAPER 820203
- Kushida T. “High Speed, Powerful and Simple Solenoid Actuator “DISOLE’” and its dynamic Analysis Results” SAE PAPER 850373
- Batoni G. “An Investigation into the Future of Two-Stroke Motorcycle Engines” SAE PAPER 830093