This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
System and Hardware Design Considerations for Mobile Phones-Sets
Annotation ability available
Sector:
Language:
English
Abstract
As cellular phone usage increases, solutions which not only meet the exact specifications, but are also economical in size, weight, and power dissipation must be found. This paper presents one such solution using a six chip set designed to meet the AMPS and TACS specifications. System requirements, architecture, as well as board level considerations and layout are discussed. In addition, the effects of shielding are presented along with test results.
Authors
Topic
Citation
Broadway, R., Fotowat, A., Killingbeck, R., Saleh, O. et al., "System and Hardware Design Considerations for Mobile Phones-Sets," SAE Technical Paper 900248, 1990, https://doi.org/10.4271/900248.Also In
References
- “The I 2 C Bus Specification” Signetics September 1988
- “Audio Processing For Cellular Radio or High Performance Transceivers” proceedings of RF Technology Expo February 1989 Fotowat A. Navid S. Engh L.
- “EIA Interim Standard, Recommended Minimum Standards for 800-MHz Cellular Subscriber Units” May 1988