This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Measurement and Simulation of Transients in Longitudinal and Lateral Tire Forces
ISSN: 0148-7191, e-ISSN: 2688-3627
Published February 01, 1990 by SAE International in United States
Annotation ability available
The design of ABS- or vehicle control systems by means of computer simulation needs adequate tire models. Recordings of the wheel speed during ABS control show oscillations caused by the rapid pressure changes in the wheel brake cylinder. Investigations in lateral tire dynamics show a phase shift between the slip angle and the lateral tire force. These transients can not be explained by simulation if the usual stationary tire input-output behaviour is supposed. Thus the investigation of the oscillations requires a different approach to the modelling of the tire.
In a first step measurements with an experimental car equipped with a computer for data acquisition and control and with various sensors - e.g. a Rotating Wheel Dynamometer - were carried out. The measurement results showed a correlation between the oscillations in the wheel speed and the braking force caused by the pressure pulses as well as high frequency oscillations in the lateral tire forces. Also the phase shift between the slip angle and the lateral tire force could be reproduced.
Transients in the tire input-output quantities were expected to result from the elastic deformation of the tire side walls and of the tread in the tire-road contact area. Correspondingly, a tire model with elastic sidewalls and an elastic tread was developed. The deformation distribution of the tread is computed by differential equations which result from the kinematic condition of the belt.
Using this model the simulation results show a tire input-output behaviour which is very similar to that obtained by measurement. It is believed that for the development of high performance ABS- or vehicle control systems this dynamic tire model is adequate.
CitationZanten, A., Erhardt, R., and Lutz, A., "Measurement and Simulation of Transients in Longitudinal and Lateral Tire Forces," SAE Technical Paper 900210, 1990, https://doi.org/10.4271/900210.
- van Zanten, A., et al, “Measurement and Simulation of Transient Tire Forces”, SAE 890640
- Martini, K.-H., “Mehrkomponenten Kraftmessung am rotierenden Rad”, Fahrzeugtechnik - Teilgebiete und Methoden, VDI-Berichte 553, Düsseldorf, 1985
- Hankel, R., et al, “OKE - ein autarkes Ortungssystem für Einsatzfahrzeuge”, Bosch Technische Berichte, Band 8, P. 57 - 65, 1986
- Heeß, G., et al, “Measurement in Experimental Cars Using Realtime Computer Systems”, SAE 880476
- Weber, R., “Reifenführungskräfte bei schnellen Änderungen von Schräglauf und Schlupf”, Habilitationsschrift, Universität Karlsruhe, 1981
- Meier-Dörnberg, K. E., et al, “Prüfstandversuche und Berechnungen zur Querdynamik von Luftreifen”, Automobil - Industrie 4/77
- Dugoff, H., et al, “Tire Performance Characteristics Affecting Vehicle Response to Steering and and Braking Control Inputs”, Highway Safety Research Institute, University of Michigan, Ann Arbor, 1969
- Bakker, E., et al, “Tyre Modelling for Use in Vehicle Dynamics Studies”, SAE 870421
- Pacejka, H. B., “Modelling of the Pneumatic Tire and its Impact on Vehicle Dynamic Behaviour” Lecture V2.03, Carl Cranz Gesellschaft (CCG), Oberpfaffenhofen 1985
- Böhm, F., “Theorie schnell veränderlicher Rollzustände für Gürtelreifen”, Ingenieur-Archiv 55, 1985, P. 30 - 44
- Laermann, F. J., “Seitenführungsverhalten von Kraftfahrzeugreifen bei schnellen Radlaständerungen”, Fortschrittberichte VDI Reihe 12 Nr. 73, Düsseldorf: VDI-Verlag 1986