This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Plastic Bumper Beam Manufacturing Analysis
Annotation ability available
Sector:
Language:
English
Abstract
The manufacturing analysis of molded plastic parts is described in detail. A PC based program is presented to analyze the material and capital cost. The program listing is included.
Recommended Content
Technical Paper | Instant Set Polymer-A New Dimension in Plastics |
Aerospace Material Specification | Bar, Rod, and Shapes Produced from 12% Graphite - 3% Polytetrafluoroethylene (PTFE) Filled Polyamide-Imide (PAI) Material |
Authors
Citation
Dubensky, R., Jay, D., and Salansky, R., "Plastic Bumper Beam Manufacturing Analysis," SAE Technical Paper 891943, 1989, https://doi.org/10.4271/891943.Also In
Computer Applications-Design, Analysis and Production of Off- Highway Equipment
Number: SP-0795; Published: 1989-09-01
Number: SP-0795; Published: 1989-09-01
References
- Miller, B. “Plastics World to Show Ford's All-Plastic Car” Plastics World May 1988 25
- Toensmeier, P.A. “Urethane Tire: Next Automotive Option?” Modern Plastics December 1987 34
- Miller, B. “Plastics Take Center Stage at S.A.E.” Plastics World. April 1988 24
- Smoluk, G. R. “Large-parts Blow Molding Takes on New Measure of Cost-Efficiency” Modern Plastics October 1987 61
- Anonymous “A Bumper with Looks that Last” Dupont Magazine July/August 1988 14
- Klein, A. J. “Plastics Lead the Drive Toward Part Consolidation” Plastics Design Forum July/August 1988 33
- Martino, R. J. “Modern Plastics Encyclopedia” October 1986 63 10A
- Rowland, R. “50% Rise in Plastics Seen in '98 Vehicles” Automotive News June 20 1988 16
- Hamilton, C. Hayden “MCAE Enters the 1990's” Manufacturing Engineering June 1989 80 82
- Anderson, K. “Engineering Workstation: A Technical Guide” Computer Graphics World April 1989 81 86