This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
A Knock Anticipating Strategy Basing on the Real-Time Combustion Mode Analysis
Annotation ability available
Sector:
Language:
English
Abstract
Although whether the cylinder gas oscillation is provoked by end-gas autoignition in a certain cycle or not is a irregular phenomenon, autoignition itself takes place in almost all of the cycles in the knocking condition. Detection of the autoignition makes it possible to realize a knock anticipating strategy. Using the decay rate of the effective heat release rate as the index, delayed autoignition with small auto-ignited mass fraction can be detected. Applying this index for the analysis of the autoignition in the acceleration process, it was clarified that heavy autoignition immediately after the acceleration caused by the selective induction of the low boiling point gasoline components into the cylinder is followed by the period where the low combustion chamber wall temperature reduces the autoignited mass fraction and suppresses the cylinder gas oscillation. It is possible to realize a remarkable improvement of the vehicle response by applying the knock anticipating strategy for the knock limit control in the acceleration conditions.
Recommended Content
Authors
Topic
Citation
Ando, H., Takemura, J., and Koujina, E., "A Knock Anticipating Strategy Basing on the Real-Time Combustion Mode Analysis," SAE Technical Paper 890882, 1989, https://doi.org/10.4271/890882.Also In
References
- Cuttler D.H. Girgis N.S. “Photography of Combustion During Knocking Cycles in Disk and Compact Chambers SAE Paper 880195 1988
- Takagi Y. Itoh T. Iijima T. “An Analytical Study on Knocking Heat Release and Its Control in a Spark Ignition Engines” SAE Paper 880196 1988
- Hirako O. Murakami N. Akishino K. “Influence of Valve Contact Noise on Knock Detection in Spark Ignition Engines” SAE Paper 880084 1988
- Anastacia G.M. Pestana G.W. A Cylinder Pressure Sensor for Closed Loop Control” SAE Paper 870288 1988
- Sawamoto K. Kawamura Y. Kita T. “Individual Cylinder Knock Control by Detecting Cylinder Pressure” SAE Paper 871911 1987
- Checkel M.D. Dale J.D. “Computerized Knock Detection from Engine Pressure Records” SAE Paper 860028 1986
- Checkel G.D. Dale J.D. “Testing a Third Derivative Knock Indicator on a Production Engine” SAE Paper 861216 1986
- Schneider M. Schmillen K. Pischinger F. “Regularities of Cylinder Pressure Oscillations and their Effects on the Combustion Process and Noise” SAE Paper 872248 1987
- Fraser F.A. Bracco F.V. “Cycle-Resolved LDV Integral Length Scale Measurement in an I.C.Engine” SAE Paper 880381 1988
- Yamamoto T. Ota T. Iwano H. “An Analysis on the Vaporization Process of Multi-Component Fuel Droplets” Nissan Technical Journal 52 59 1986