This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
An Efficient Model for Valvetrain and Spring Dynamics
Annotation ability available
Sector:
Language:
English
Abstract
A model for valvetrain dynamics is presented, which aims at both accuracy and efficiency. Important aspects in achieving these aims were
(i) to formulate the dynamical equations in terms of deviations from the kinematic displacement.
(ii) a tappet stiffness which varies with contact point.
(iii) a model of the hydraulic lash adjuster.
(iv) a model of valve spring dynamics in terms of spring surge modes.
The model results show good agreement with measured accelerations for a DOHC engine with direct acting bucket tappets. Moreover the model allows one to quickly gain an insight into the dynamics of valvetrains.
Recommended Content
Authors
Citation
Phlips, P., Schamel, A., and Meyer, J., "An Efficient Model for Valvetrain and Spring Dynamics," SAE Technical Paper 890619, 1989, https://doi.org/10.4271/890619.Also In
References
- CHEN F.Y. 1977 “A survey of the state of the art of cam system dynamics” Mechanism and machine theory 12 201 224
- PISANO A. FREUDENSTEIN F. 1983 “An experminental and analytical investigation of the dynamic response of a high-speed cam-follower system. Part 2: A combined, humped/distributed parameter dynamic model” Trans. ASME, J. Mech., Trans., Auto. Des 105 699 704
- AKIBA K. KAKIUCHI T. 1988 “A dynamic study of engine valving mechanism: determination of the impulse force acting on the valve” SAE Paper 880389
- CHAN C. PISANO A. 1987 “Dynamic model of a fluctuating rocker arm ratio cam system” Trans. ASME, J.Mech., Trans., Auto. Des 109 356 365
- CHEN F.Y. 1973 “Analysis and design of cam-driven mechanisms with nonlinearities” Trans, ASME, J. Eng. for Industry 1973 685 694
- CHEN F.Y. POLVANICH N. 1975 “Dynamics of high-speed cam-driven mechanisms. Part 1: Linear system model” Trans. ASME, J. Eng. for Industry 1975 769 776 “Dynamics of high-speed cam-driven mechanism. Part 2: Nonlinear system models” Trans. ASME, J. Eng. for Industry 1975 777 784
- KLOTTER K. 1978 “Technlsche Schwingungslehre, 3. Auflage” Springer Verlag, New York 1978
- KRAMER E. 1984 “Maschinendynamik” Springer Verlag, New York 1984
- BARKAN P. 1953 “Calculation of high-speed valve motion with a flexible overhead linkage” Trans. SAE 61 687 700
- PISANO A. FREUDENSTEIN F. 1983 “An experimental and analytical investigation of the dynamic response of a high-speed cam-follower system. Part 1: Experimental Investigation” Trans. ASME, J. Mech., Trans., and Auto. Des 105 692 698
- SUGIURA A. et al 1983 “Development of self-contained hydraulic valve lifter” SAE Paper 831221
- STRAUBEL M. 1966 “Beitrag zur Erfassung und Beeinflussung des Schwingungsverhaltens von Nockengetrieben” Motor Technische Zeitschrift 27 403 410