This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Fiber-Optic Instrumented Spark Plug for Measuring Early Flame Development in Spark Ignition Engines
Annotation ability available
Sector:
Language:
English
Abstract
An optical probe for measuring the motion and rate of growth of the early flame kernel in spark ignition engines is described. The probe consists of a standard spark plug with eight optical fibers installed in a ring at the base of the threaded region of the plug. The fibers collect the light emitted from the flame as it crosses the field of view of the fibers, and transmit the light to photomultiplier tubes. The time from ignition until detection of the flame is used to compute the average flame velocity in the direction of each fiber relative to the spark location. The real-time data acquisition system permits statistical analysis of cycle-by-cycle variations in the combustion rate. Because the probe was built using a standard 14 mm spark plug, it can be used in unmodified production automotive engines.
To demonstrate this device, measurements are presented comparing the flame kernel evolution between unscavenged and scavenged engine cycles, and between low-swirl and high-swirl in-cylinder flow fields. Laser schlieren visualization of the combustion process is used to validate the response of the probe. It is shown that both the displacement and growth rate of the flame kernel can be measured, and that small effects related to the orientation of the ground electrode can be sensed, Finally, two parameters characterizing the average convection velocity and expansion speed are proposed for correlating early flame development with engine pressure measurements.
Recommended Content
Authors
Topic
Citation
Witze, P., Hall, M., and Wallace, J., "Fiber-Optic Instrumented Spark Plug for Measuring Early Flame Development in Spark Ignition Engines," SAE Technical Paper 881638, 1988, https://doi.org/10.4271/881638.Also In
References
- Young M. B. “Cyclic Dispersion - Some Quantitative Cause-and-Effect Relationships,” SAE Paper 800459 1980
- Keck J. C. Heywood J. B. Noske G. “Early Flame Development and Burning Rates in Spark Ignition Engines and Their Cyclic Variability,” SAE Paper 870164 1987
- Spicher U. Velji A. “Measurements of Spatial Flame Propagation and Flow Velocities in a Spark Ignition Engine,” Twentieth Symposium (International) on Combustion The Combustion Institute 19 1984
- Spicher U. Kollmeier H. P. “Detection of Flame Propagation during Knocking Combustion by Optical Fiber Diagnostics,” Trans. SAE, Fuels and Lubricants 95 552 1986
- Spicher U. Velji A. Huynh N. H. Kruse F. “An Experimental Study of Combustion and Fluid Flow in Diesel Engines,” SAE Paper 872060 1987
- Douaud A. de Soete G. Henault C “Experimental Analysis of the Initiation and Development of Part-Load Combustions in Spark-Ignition Engines,” SAE Paper 830338 1983
- Johnston S. C. Robinson C. W. Rorke W. S. Smith J. R. Witze P. O. “Application of Laser Diagnostics to an Injected Engine,” Trans. SAE 88 353 1979
- Witze P. O. Vilchis F. R. “Stroboscopic Laser Shadowgraph Study of the Effect of Swirl on Homogeneous Combustion in a Spark-Ignition Engine,” Trans. SAE 90 979 1981