This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Influence of Valve Noise on Knock Detection in Spark Ignition Engines
Annotation ability available
Sector:
Language:
English
Abstract
Valve noise is one of the factors that deteriorate the signal-to-noise ratio in the detection of combustion knock in spark ignition engines by means of a knock control system with a conventional knock sensor and a higher frequency band-pass filter. It was determined that one of the principal mechanisms of valve noise increase is the eccentricity between the valve seat face and the insert seat face at valve contact in addition to excess valve contact speed. One of the reasons for this eccentricity is the offset between the centers of the valve guide and insert caused by cylinder head distortion due to fastening of the cylinder head and thermal distortion of the insert. Other reasons include excess clearance caused by the abrasion of the valve guide and stem, and valve tilt increase caused by inherent valve spring bend.
Recommended Content
Authors
Topic
Citation
Hirako, O., Murakami, N., and Akishino, K., "Influence of Valve Noise on Knock Detection in Spark Ignition Engines," SAE Technical Paper 880084, 1988, https://doi.org/10.4271/880084.Also In
References
- Decker H. “Knock Control of Gasoline Engines-A Comparison of Solutions and Tendencies, with Special Reference to Future European Emission Legislation” SAE 850298
- Schaepertoens H. et al. “Multidimentional Modeling of Knocking Combustion in SI Engines” SAE 850502
- Spicher U. et al. “Detection of Flame Propagation During Knocking Combustion by Optical Fiber Diagnostics” SAE 861532
- Ueda A. “Knock Control System” Journal of” JSAE 36 10 1982
- Kawamura Y. et al. “Recent Technologies in Knocking-detection and it's Quantitative Processing in Spark Ignition Engine” Journal of JSAE 40 11 1986
- Kaji K. et al. “Development of Knock Sensor” SAE 861375
- Hayashi Y. et al “Analysis of Combustion Noise Generation in an Engine” Transaction of Nissan Technical Review 15 1980
- Nakamura N. et al. “Development of Knock Control System Detecting High Frequency Vibration Signal” Toyota Engineering 37 1 1987
- Draper C. S. “The physical effects of detonation in a closed cylindrical chamber” N.A.C.A. 493 1934
- Kojima N. et al “Combustion Impact Noise of Internal Combustion Engine by Means of Single Explosion Excitation, 1st Report” Transactions of JSME 51 471 1985
- Shimoseki M. et al. “On the Helical Compression Spring with the Fixed End” Transactions of the Japan Institute of Springs 24, 46 1976