This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Certification of Natural Laminar Flow Technology
Annotation ability available
Sector:
Language:
English
Abstract
Although the concept of Natural Laminar Flow (NLF) has existed for many years, only recently have modern aircraft fabrication techniques and airfoil design technology reached the level of maturity necessary to permit the achievement of significant amounts of NLF on production aircraft. Current design trends toward turbocharging and pressurized cabins are pushing new aircraft into higher altitude regions where low unit Reynolds numbers are more conducive to the achievement of NLF. Extensive use of composite materials is providing the smooth surfaces necessary to permit NLF. Recent experimental designs have demonstrated 70% chord runs of NLF on upper and lower wing surfaces, as well as significant NLF on fuselages, empennages and propellers.
A consequence of achieving highly laminar boundary layers, however, is that an aircraft may then be susceptible to large performance losses when environmental or operating conditions result in early transition of the boundary layer. Further, if the NLF airfoil sections are improperly designed, stability and controllability problems can result.
The FAA is currently working with NASA and the industry to evaluate the adequacy of existing regulations and procedures for certifying highly laminar aircraft designs. This paper will cover some of the FAA concerns about the potential effects of loss of NLF on aircraft performance and handling qualities. The paper will also discuss what the FAA is doing to help address these concerns and interim guidelines that are being used to certify a current project that is expected to achieve large amounts of NLF.
Recommended Content
Authors
Topic
Citation
Verstynen, H. and Sexton, B., "Certification of Natural Laminar Flow Technology," SAE Technical Paper 871848, 1987, https://doi.org/10.4271/871848.Also In
References
- Holmes, B.J. O'Bara, C.J. Yip, L.P. “Natural Laminar Flow Experiments on Modern Airplane Surfaces” June 1984
- Gabriel, E. A. Tankesley, E. L. “Certification Aspects of Airplanes Which May Operate with Significant Natural Laminar Flow” Proceedings of the Laminar Flow Aircraft Certification Workshop April 1985
- Williams, K.L. Vijgen, P. Roskam, J. “Natural Laminar Flow and Regional Aircraft” SAE Paper 850864 April 1985
- Somers, D.M. “Design and Experimental Results for a Flapped Natural Laminar Flow Airfoil for General Aviation Applications” June 1981
- Van Dam, C.P. Holmes, B.J. “Boundary Layer Transition Effects on Airplane Stability and Control” August 1986
- Yip, L.P. Coy, P.F. “Wind Tunnel Investigation of a Full-Scale Canard-Configured General Aviation Aircraft” 1982
- Van Dam, C.P. “Natural Laminar Flow Airfoil Design Considerations for Winglets on Low-Speed Airplanes” December 1984
- Hoerner, S.F. Borst, H.V. “Fluid-Dynamic Lift” 1975
- Stough, H.P. Patton, J.M. “The Effects of Configuration Changes on Spin and Recovery Characteristics of a Low-Wing General Aviation Research Airplane” August 1979
- Murri, D.G. Jordan, F.L. Nelson, R. Davis, P.J. “Wind-Tunnel Investigation of a General Aviation Airplane Equipped With A High Aspect-Ratio, Natural-Laminar-Flow Wing” SAE Paper 871019 April 1987