This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
A Multi-Sensing Device for Hydraulic Control Systems
Annotation ability available
Sector:
Language:
English
Abstract
A multi-sensing device with a piezoresistive pressure sensor for hydraulic system control was developed, applied to a hydraulic belt conveyor and tested. One single pressure sensor was installed inside a hydraulic motor. By analyzing the output signals, the following engineering variables were measured and could be analyzed: running speed, torque, absolute displacement, horsepower, pressure, mass flow rate of conveyed materials and even malfunction diagnosis. High speed resolution, torque and mass flow rate measurements are focused on in this paper. Based on data sampling rates and windows, high resolution speed data from a hydraulic motor sensor was measured. Relationships between mass flow rates on the conveyor belt and torques due to loading under various situations are presented.
Authors
Citation
Cho, S., Krutz, G., and Miles, G., "A Multi-Sensing Device for Hydraulic Control Systems," SAE Technical Paper 871603, 1987, https://doi.org/10.4271/871603.Also In
References
- CEMA 1979 “ Belt Conveyors for Bulk Materials ” 2nd CBI Publishing Company Inc. New York 76 203
- Cho, Seong I. 1986 “ Correlation of Torque and Mass Flow Rate for Belt Conveying of Agricultural Materials ” Master Thesis Agricultural Engineering Dept., Purdue University
- Dransfield, P. 1981 “ Hydraulic Control Systems-Design and Analysis of Their Dynamics ” Springer-Verlag New York 95 182
- Evans, M.D. Krutz G.W. Beasley D.B. 1983 “ Integral Hydraulic Motor Speed and Torque Sensor ” ASAE paper 83-1595 ASAE St. Joseph, Mich. 49085
- Hansen, D. Krutz G.W. 1984 “ Hydraulic Motor Speed, Torque, and Rotational Displacement Sensing ” 40th National Conference on Fluid Power 38 237 246 1987
- Hennessey, M. 1985 “ A Microcomputer Data Acquisition Package for Demonstration of a Hydraulic Sensor ” Research paper for Ag Engrg. Purdue University
- Merritt, H.E. 1967 “ Hydraulic Control Systems ” John Wiley & Sons Inc. New York 54 75 132 173
- Miles, G. E. 1984 “ On-Line Data Acquisition ” Agricultural Engineering, Purdue University IN
- Renvert, P. Weiler W. 1983 “ The Comparison of Various Test Methods to Determine the Starting and Low Speed Characteristics of Hydraulic Motors with regard to their Practical Use ” J. of Fluid Control 14 3 63 91
- Sensym 1983 “ Pressure Transducer Handbook ” Sensym Inc. Sunnyvale, CA 1 11
- Texas Instruments 1983 “ VPU 200 Programming and Control Vision Unit Manual ” 2nd Texas Instruments Industrial Systems Johnson City, TN