This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Simulation of Hydraulically Adjustable Wheel Base Unit for Mobile Equipment
Annotation ability available
Sector:
Language:
English
Abstract
A need to vary the wheel base during operation exists for some mobile equipment. This need can be caused by legal considerations or the geometry of the haul road. To meet this need, we consider a hydraulically-operated device used as a fifth wheel. This type of unit is being built and installed on some tractor trailer combinations.
Since the apparatus can be operated with the vehicle in motion, the system needs to be analyzed under various dynamic conditions. System pressure peaks and component operation is examined under a variety of conditions involving road surface irregularities and the effect of striking obstructions such as loading docks. Some recommendations for design improvement are included.
The analysis was carried out with the use of the IBM-CSMP (Continuous System Modeling Program) (1).* The purpose of the work was to gain preliminary knowledge regarding probable operation of the apparatus.
Citation
Gassman, M. and Dostal, G., "Simulation of Hydraulically Adjustable Wheel Base Unit for Mobile Equipment," SAE Technical Paper 870808, 1987, https://doi.org/10.4271/870808.Also In
References
- Speckhart, F. H. Green W. L. 1976 A guide to using CSMP-the continuous system modeling program Englewood Cliffs, N.J. Prentice-Hall, Inc.
- Taborek, J. J. 1957 Mechanics of vehicles Cleveland, Ohio Penton Publishing Co.
- Wong, J. Y 1978 Theory of ground vehicles New York Wiley Interscience