This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Heat Transfer into Ceramic Combustion Chamber Wall of Internal Combustion Engines
Annotation ability available
Sector:
Language:
English
Abstract
The authors developed the optimum thin film thermocouples in terms of materials, shape and dimensions to make instantaneous surface temperature and heat flux measurements of combustion chamber wall in internal combustion engines with accuracy by the computer analysis. And they succeeded to make thin film thermocouple in ceramic piston, by the application of the above technique. Then, the instantaneous surface temperature was measured to obtained the instantaneous heat flux on the ceramic plate fixed on top of the piston. As a result, the following interesting phenomena have been obtained.
- (1) Contrary to their expectation, amount of heat transfer into the piston surface during combustion period on the ceramic wall is larger than on a conventional Al-alloy wall.
- (2) It is found that the ceramic wall of the combustion chamber can not decrease in cooling loss during combustion, so the engine out put does not increase except by use of turbocompound device.
- (3) The overall heat transfer on the ceramic wall in a cycle is, however, smaller than on the conventional Al-alloy wall since more heat flows backward from high temperature wall to the low temperature air in combustion chamber during in intake and compression strokes.
Recommended Content
Citation
Enomoto, Y. and Furuhama, S., "Heat Transfer into Ceramic Combustion Chamber Wall of Internal Combustion Engines," SAE Technical Paper 861276, 1986, https://doi.org/10.4271/861276.Also In
References
- Kamo, R. Bryzik, W. SAE Paper 780068 1978 213
- Kamo, R. Bryzik, W. SAE Paper 810070 1981 263
- Woods, M. E. Oda, I. SAE Paper 820429 1982
- Tovell, J. F. SAE Paper 830316 1983 55
- Wilsted, H. D. SAE Paper 820432 1982
- Enomoto, Y. Furuhama, S. Bulletin of JSME 28-235 1985 108
- Enomoto, Y. Furuhama, S. Bulletin of JSME 29-256 1986
- Enomoto, Y. Furuhama, S. Minakami, K. Bulletin of JSME 28-238 1985 647
- Enomoto, Y. Furuhama, S. Bulletin of JSME 29-253 1986
- Enomoto, Y. Furuhama, S. Bulletin of JSME 29-250 1986 1211
- Oguri, T. Trans. JSME 24-184 1958 991
- Overby, V. D. et al. SAE Trans. 69 1961 461
- Yoshida, S. et al. Trans. JSME 45-391 1979 416
- LeFeuvre, T. et al. SAE Trans. 690464 1969
- Hohenberg, G. F. SAE Trans. 790825 1979 61
- Eichelberg, G. Engineering 1939 463
- Woschni, G. Fieger, J. MTZ 42 1981 6
- Woschni, G. Sihling, K. SAE Paper 790833 1979 95