This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
An Experimental Study of Flow Through a Rotating Disc Valve
Annotation ability available
Sector:
Language:
English
Abstract
It is known that the mass flow rate through poppet valves of 4-stroke cycle engines and through piston valves of 2-stroke cycle engines decrease with increase in engine speed. In this paper, a disc-type rotary valve was used to experimentally analyze the decrease in flow rate at high rotational speeds and to determine what variables, other than rotational speed, give rise to the observed behaviour. These variables have been included in an empirical equation which is representative of the measured flow characteristics.
Authors
Citation
Iwamoto, J. and Deckker, B., "An Experimental Study of Flow Through a Rotating Disc Valve," SAE Technical Paper 841092, 1984, https://doi.org/10.4271/841092.Also In
References
- Benson R.S. Whitfield A. “An Experimental Investigation of the Non-Steady Flow Characteristics of a Centrifugal Compressor” Proc. I. Mech. E. 180 1965-66 1 20
- Miyashita T. Tomita T. Ishihara O. “Performance of Radial Turbine Under Unsteady-Flow Conditions” Ishikawajima-Harima Giho 13 3 1975 259 269
- Brandstetter W. “Der Gas-und Flussig-keitsdurchsatz bei periodisch-instantionaren Stromungen im Ansaugsystem der Verbrennun-gskraftmmaschine” Doktordissertation, E.H.T. 1965 1 177
- Wallace F.J. Miles J. “Performance of Inward Radial Flow Turbines under Unsteady Flow Conditions with Full and Partial Admissions” Proc. I. Mech. E. 185 1970-71 1091 1105
- Kosuge H. “Investigation Concerning the Characteristics of Radial Flow Turbines under Pulsating Flow Conditions” Ph.D. Thesis Keio Univ. 1976 1 171
- Stanitz J.D. Lucia R.E. Masselle F.L. “Steady- and Intermittent-Flow Coefficients of Poppet Intake Valves,” NACA TN No. 1035 1946 1 9
- Komotori K. Watanabe E. “A Study of the Delivery Ratio Characteristics of Crankcase-Scavenged Two-Stroke Cycle Engines” SAE Trans. 78 1969 608 636
- Benson R.S. “Experiments on Two-Stroke Engine Exhaust Ports Under Steady and Unsteady Flow Conditions” Proc. I. Mech. E. 173 19 1959 511 546
- Kastner L.J. Williams T.J. White J.B. “Poppet Inlet Valve Characteristics and Their Influence on the Induction Process” Proc. I. Mech. E. 178 36 1963-64 955 978
- Japan Industrial Standards, Z 8762 1971
- Deckker B.E.L. Chang Y.F. “An Investigation of Steady Compressible Flow Through Thick Orifices” Proc. I. Mech. E. 180 1965-66 312 323
- Iwamoto J. “A Study of Flow Characteristics of a Rotary Valve” 740 6 1974 105 108
- Iwamoto J. “Experimental Investigation of a Rotary Valve” Research Reports Tokyo Denki Univ. 22 1974 127 150