This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
A Closed-Loop A/F Control Model for Internal Combustion Engines
Annotation ability available
Sector:
Language:
English
Abstract
A mathematical model is developed which describes the operation of an A/F control system containing an engine, an exhaust gas oxygen sensor, and a feedback controller. The dependence of model parameters on engine operating conditions is discussed, and the model is used to compare integral and proportional/integral control algorithms. Actual data obtained on an engine-dynamometer are presented to test the validity of the model.
Recommended Content
| Technical Paper | Non-Linear Model-Based Throttle Control |
| Technical Paper | Air-to-Fuel Ratio Control of Gas Engines Using Response Characteristics of Three-Way Catalysts under Dynamic Operation |
Topic
Citation
Hamburg, D. and Shulman, M., "A Closed-Loop A/F Control Model for Internal Combustion Engines," SAE Technical Paper 800826, 1980, https://doi.org/10.4271/800826.Also In
References
- Zechnall R. Baumann G. Eisele H. “Closed-Loop Exhaust Emission Control System with Electronic Fuel Injection.” Paper 730566 presented at SAE National Automobile Engineering Meeting May 1973
- Kaneko Y. Kobayashi H. Komagome R. Nakagami T. Fugui T. “Catalyst System Development,” Paper 770197 presented at SAE International Automotive Engineering Congress and Exposition February 1977
- Shulman M. A. Hamburg D. R. “Non-Ideal Properties of ZrO 2 and TiO 2 Exhaust Gas Oxygen Sensors.” Paper 800018 presented at SAE International Automotive Engineering Congress and Exposition February 1980
- Cassidy J. F. “Electronic Closed-Loop Controls for the Automobile.” Paper 740014 presented at SAE International Congress and Exposition February 1974
- Engh G. T. Wallman S. “Development of the Volvo Lambda-Sond System.” Paper 770295 presented at SAE International Automotive Engineering Congress and Exposition February 1977
- Canale R. P. Winegarden S. R. Carlson C. R. Miles D. L. “General Motors Phase II Catalyst System.” Paper 780205 presented at SAE International Automotive Congress and Exposition February 1978
- Wu H. Blumberg P. N. “An Attenuation and Transport Delay Model for Single Point Closed-Loop Fuel Metering Systems.” Paper 790172 presented at SAE International Automotive Congress and Exposition February 1979
- Haslett R. A. Eidson T. M. “Equivalence Ratio Meter.” Paper 770219 presented at SAE International Automotive Congress and Exposition February 1977
- Hamburg D. R. Shulman M. A. Aquino C. F. Palmer M. D. “Frequency Response Characterization and Compensation of the Ricardo Equivalence Ratio Monitor.”
- Blumberg P. N. Wu H. Auiler J. E. “A Methodology for Evaluation and Optimization of Three-Way Catalyst Based, Low NOx Emission Control Systems.”
- Hamburg D. R. Hyland J. E. “A Vaporized Gasoline Metering System for Internal Combustion Engines.” Paper 760288 presented at the SAE International Automotive Congress and Exposition February 1976
- Lanczos C. “Discourse on Fourier Series,” Hafner Publishing Co. New York 1966 36 7
- Fleming W. J. “Sensitivity of the Zirconia Oxygen Sensor to Temperature and Flow Rate of Exhaust Gas.” Paper 760020 presented at the SAE International Automotive Congress and Exposition February 1976
- Hamaan E. Manger H. Steinke L. “Lambda-Sensor with Y 2 O 3 -Stabilized ZrO 2 -Ceramic for Application in Automotive Emission Control Systems.” Paper 77041 presented at the SAE International Automotive Engineering Congress and Exposition February 1977