This content is not included in your SAE MOBILUS subscription, or you are not logged in.
A Comprehensive Approach to Icing Certification
ISSN: 0148-7191, e-ISSN: 2688-3627
Published February 01, 1975 by SAE International in United States
Annotation ability available
During the certification of an airplane, the chances of encountering icing conditions as defined in the Federal Aviation Regulations (FAR) are so small that the satisfactory performance of an anti-icing system has to be established by methods other than flight tests in FAR icing conditions. The regulations, however, do not specify a set of standard procedures for evaluating the anti-icing capability of a system. The methods used within the industry, therefore, vary very widely in type, scope, and accuracy.
This paper describes an approach used by Gates Learjet that is simple and inexpensive to be within the reach of any manufacturer, and accurate enough to contribute towards the creation of a standard procedure within the whole industry.
|Technical Paper||IT Security Management of Aircraft in Operation: A Manufacturer's View|
|Journal Article||Average Probability Calculation Methods for System Safety Analysis|
|Technical Paper||State of the Art Aircraft Interior Designs|
CitationKutty, T., "A Comprehensive Approach to Icing Certification," SAE Technical Paper 750507, 1975, https://doi.org/10.4271/750507.
- Bowden D.T. Gensemer A.E. Speen C.A. “Engineering Summary of Airframe Icing Technical Data.” Federal Aviation Agency 1964
- Neel C.B. “A Procedure for the Design of Air-Heated Ice-Prevention.” NACA 1954
- Gray V.H. “Simple Graphical Solution on Heat-Transfer and Evaporation From Surface Heated to Prevent Icing.” NACA 1952
- Gelder T.F. Lewis J.P. Koutz S.L. “Icing Protection for a Turbojet Transport Airplane: Heating Requirements, Methods of Protection and Performance Penalties.” NACA 1953
- Sogin H.H. “A Design Manual for Thermal Anti-icing Systems.” 1954
- Federal Aviation Administration “Aircraft Ice Protection.” 1971