This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Statistical Tolerancing as it Relates to Quality Control and the Designer (6 times 2.5 = 9)
ISSN: 0148-7191, e-ISSN: 2688-3627
Published February 01, 1968 by SAE International in United States
Annotation ability available
Event: Mid-Year Meeting
Three methods of tolerancing are described. In widest use is the method of extremes, which produces unnecessarily close limits on the components. For the same over-all limits on the assembly the probability method allows wider limits on the components, but there are some unrealistic assumptions involved. A third method is described which results in tolerances falling between the other two. A case history is discussed comparing the three methods.
|Technical Paper||Powder Anti-Chip Coatings for Auto Bodies|
|Technical Paper||Vehicle Design Parameters for Oilwell Servicing Equipment|