This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Numerically Controlled Milling for Making Experimental Turbomachinery
ISSN: 0148-7191, e-ISSN: 2688-3627
Published February 01, 1967 by SAE International in United States
Annotation ability available
Utilization of numerically controlled milling has been found particularly attractive in producing, in limited quantities, the three-dimensional curved surfaces characteristic of turbomachinery. In experimental and developmental programs its use can result in decreased fabrication cost, reduced lead time, and improved dimensional accuracy. Following a review of the general classifications of numerically controlled milling machines available for manufacture of such parts, illustrations are given of some of the procedures and techniques employed in their use. A variety of parts made using numerical control serve as examples.
CitationYu, M. and Amann, C., "Numerically Controlled Milling for Making Experimental Turbomachinery," SAE Technical Paper 670096, 1967, https://doi.org/10.4271/670096.