This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
The Feasibility of a Mach 7 Transport Employing Airbreathing Propulsion Systems
Annotation ability available
Sector:
Language:
English
Abstract
Trip time requirements between points on earth can be reduced by use of hypersonic aircraft if the range is sufficiently large so as to minimize the effect on average speed of the time of acceleration and deceleration. See Fig. 1. The objective of this study is to determine if it is technically feasible to use airbreathing propulsion systems to provide an intercontinental vehicle which will bring virtually all major cities of the world within two hours flying time of each other.
An extensive study of various propulsion and performance aspects of a single-stage long range Mach 7 delta wing trans port, Fig. 2, 30,000 lb payload (125 passengers and cargo), has been completed. The study encompasses consideration of the propulsive performance of a hypersonic ramjet design featuring lift augmentation. Particular attention is given to the influence of geometry, equivalence ratio, diffuser recovery characteristics, and boundary layer bleed on this performance. A variety of design charts permitting immediate engine sizing is presented. Next, considerable attention is given to climb and acceleration which is accomplished in two phases; a Mach 0-3.6 turbojet phase, and a Mach 3.6-7.0 ramjet phase. The significance of the number of turbojet engines, ramjet engine size, called-for tangential acceleration, and gross weight at take-off for trajectory characteristics, climb-time, climb-fuel, and climb-range is is presented. Finally, the significance of all these factors for overall trip performance is given.
The results of the study indicate that present state-of-the-art in propulsion, aerodynamics, insulation, cooling, and structures can provide a hypersonic airbreathing transport capability. A 700,000 lb configuration could transport the above payload 3600 nautical miles with a fuel reserve adequate for descent and landing techniques similar to those used in present transport operation. Fully automatic flight control from take-off through landing would provide a means for substantially reducing fuel reserves. 4500 nautical miles would be possible if the fuel reserve requirement could be reduced to zero. The trip times would be 82 and 94 minutes respectively.
These results demonstrate that it is technically feasible to construct a hypersonic transport of intercontinental range. It may be anticipated that continued research in troublesome problem areas will suggest solutions which will increase the ratio of payload weight to gross weight and hence increase the efficiency of hypersonic transport.
Recommended Content
Authors
Topic
Citation
Pietrangeli, G. and Nice, E., "The Feasibility of a Mach 7 Transport Employing Airbreathing Propulsion Systems," SAE Technical Paper 610102, 1961, https://doi.org/10.4271/610102.Also In
References
- Dugger Gordon L. Monchick Louis “External Burning Ramjets - I, Preliminary Feasibility Study,” Paper presented at 13th Annual Meeting of American Rocket Society New York November 1958 *
- Sebold R. C. “Commercial Air Transportation Beyond the Subsonic Jets,” Paper presented at IAS 27th Annual Meeting New York January 1959
- Nice E. V. “Great Circle Distances between Principle. Cities of the World,” BPD 59C-47, 15 June 1959
- Dugger Gordon L. “A Future for Hypersonic Ramjets,” in Astronautics April 1959
- Connor R. P. “A Survey of Supersonic Diffuser Performance and Design Limitations and an Estimation of External-Internal-Compression Diffuser Performance Applicable to Hypersonic Propulsion Requirements,” BPD 59C-72 29 September 1959 *
- Maglieri D. J. Carlson H. W. “The Shock-Wave Noise Problem of Supersonic Aircraft in Steady Flight,” NASA Memo 3-4-59L April 1959
- Hibbard Hall Bailey Robert A. “The Case for the Supersonic Transport” in Aero/Space Engineering July 1959
- Woolard H. W. Cramer R. H. “Equilibrium Surface Temperature Resulting from Aerodynamic Heating and Radiant Cooling for Turbulent-Boundary-Layer Flow over a Flat Plate,” APL/JHU CF-2701, 28 February 1958
- Rutowski Edward S. “Energy Approach to the General Aircraft Performance Problem,” in Journal of Aeronautical Sciences March 1954
- Miele Angelo Cavoti Carlos R. “Combined Operations with and without Afterburning for Minimum Fuel Consumption in Level Flight,” NASA TND-151 September 1959
- Avery W. H. Dugger G. L. Walker J.H. “Prospects and Design Considerations for Hypersonic Flight,” Paper presented to IAS Meeting March 1959 Cleveland, Ohio. *
- Faro IDV “Cooling of the Cabin for a Hypersonic Transport,” BPD 60C-39, 5 May 1960
- Pearson J. B. Jr. Pfeiffer R. James “Supersonic Transports-Considerations of Design, Powerplant and Performance,” B.C. Monesmith and Robert A. Bailey “Operational Factors, Financial Considerations and National Policy,” 2nd Supersonic Transports (Proceedings), Institute of the Aeronautical Sciences, No. FF-26 January 1960
- Taylor R. J. et al “Investigation of Weights for Wings and Tails of Supersonic Vehicles,” CAL/CM-384 July 1947
- Several informal discussions with Mr. Camwood Mr. Blevins of BBE, APL/JHU.
- Gerald Corning “Airplane Design,” 1953 Box No. 14 College Park Maryland
- McCarty T. A. Weingartner A. C. “Heat Transfer and Insulation Considerations for an External Ramjet with Specific Application to M = 7.0 Flight,” BPD 60C-64, 13 July 1960
- Ulman Edward F. Bertram Mitchel H. “Aerodynamic Characteristics of Low-Aspect-Ratio Wings at High Supersonic Mach Numbers,” NACA RM L53I23 November 2 1953 *
- Pitts William C. Neilsen Jack N. Kaattari George E. “Lift and Center of Pressure of Wing-Body-Tail Combinations at Subsonic, Transonic, and Supersonic Speeds,” NACA Report 1307.
- Grimminger G. Williams E. P. Young G. B. W. “Lift on Inclined Bodies of Revolution in Hypersonic Flow,” Journal of Aeronautical Sciences November 1950
- Emerson Horace F. “Wind-Tunnel Investigation of the Effect of Clipping the Tips of Triangular Wings of Different Thickness, Camber, and Aspect Ratio - Transonic Bump Method,” NACA TN 3671 June 1956
- Low George M. “Boundary Layer Transition at Supersonic Speeds,” NACA RM E56E10 August 1956 *
- Royal Aircraft Establishment “Handbook of Supersonic Aerodynamic Data.” *
- SSGM Feasibility Report I
- Love Eugene S. “Base Pressure at Hypersonic Speeds on Two-Dimensional Airfoils and on Bodies of Revolution with and without Fins having Turbulent Boundary Layers,” NACA TN 3819 January 1957
- General Electric Co. “Properties of Combustion Gases System: C n H 2n - Air Volume I. Thermodynamic Properties,” New York McGraw-Hill Book Co., Inc. 1955
- Keenan Joseph H. Joseph Kage “Gas Tables,” New York John Wiley and Sons, Inc. 1948
- Kennedy E. C. Sonheim D. W. Anne Mae Barnes “New Mach Number Tables for Internal Ramjet Flow Analysis, γ = 7/5 and γ = 9/7,” CF-1798 April 7 1952
- Ames Research Staff “Equations, Tables, and Charts for Compressible Flow,” NACA Report 1135 1953
- Antonio Ferri G.B. “Elements of Aerodynamics of Supersonic Flow,” New York The Macmillan Co. 1949
- Fehlner L. F. Nice E. V. “Tabulation of Standard Atmospheres at 100-Foot Intervals of Altitude,” TG 313-1 August 1958
- “Hypersonic Transport Climb and Dive Trajectory Program,” CC Problem Number 353.