This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Research of the Inductive Sensor of the Electropneumatic Clutch Control System for the Mechanical Transmission at Change of Ambient Temperature
Technical Paper
2021-01-0679
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Event:
SAE WCX Digital Summit
Language:
English
Abstract
This article describes experimental research results of the inductive sensor of the electropneumatic clutch control system for the mechanical transmission. Inductive sensors are used to determine the position of the car body, the position of the controls and the position of the rod of the clutch control actuator. The design of the clutch pedal position sensor is proposed, which can be brought into line with the master cylinder to unify the clutch control systems. Complete unification of the automated electropneumatic clutch control system for trucks will allow creating modifications in which it is possible to completely abandon the use of brake fluid in the drive, which will improve the ergonomic and environmental performance of the vehicle. The advantages of such sensors are the ability to receive a signal in digital form without additional converters, the ability to work using only two wires, no contact between moving parts, resistance to aggressive environments and compact size. The disadvantage is the influence of ambient temperature on the electrical parameters of the sensor (inductance and resistance) and on the measuring circuit of the electronic control unit. The temperature effect creates significant deviations in the data received by the processor. During the laboratory experimental study, the influence of ambient temperature on the measurement data in the temperature range of -45°С + 45°С was determined separately for the sensor and for the sensor with the measuring system. Significant nonlinearity of the characteristic was determined. The effect of spontaneous operation of the clutch control system during changes in ambient temperature was experimentally obtained. The influence of temperature change on the measuring range of the inductive sensor is also revealed. The transfer characteristic of the sensor (% /mm) is determined. The approach that provides a stable transfer characteristic within the specified temperature range is proposed.
Authors
- Mykola Grygorovych Mikhalevich - Kharkov National Auto and Highway University
- Dziubenko Oleksandr - Kharkov National Auto and Highway University
- Dmitry Leontiev - Kharkov National Auto and Highway University
- Viktor Bogomolov - Kharkov National Auto and Highway University
- Valeriy Klimenko - Kharkov National Auto and Highway University
- Alexandr Yarita - Kharkov National Auto and Highway University
- Olena Chevychelova - Kharkov National Auto and Highway University
Topic
Citation
Mikhalevich, M., Oleksandr, D., Leontiev, D., Bogomolov, V. et al., "Research of the Inductive Sensor of the Electropneumatic Clutch Control System for the Mechanical Transmission at Change of Ambient Temperature," SAE Technical Paper 2021-01-0679, 2021, https://doi.org/10.4271/2021-01-0679.Also In
References
- https://www.nxp.com/docs/en/data-sheet/KMZ41.pdf
- https://www.hitano.com.tw/wp-content/uploads/doc/MLCC-Y5V_20140919.pdf
- https://www.hitano.com.tw/wp-content/uploads/doc/MLCC-X7R_20190116.pdf
- https://www.hitano.com.tw/wp-content/uploads/doc/MLCC-NPO_20200916.pdf
- https://www.wabco-customercentre.com/catalog/uk_UA/4410500110?cclcl=uk_UA
- https://www.knorr-bremsecvs.com/en/products_1/transmission_management_/transmission_management_1.jsp
- https://www.zf.com/products/en/cars/products_47296.html#products_anchor_link_c4655462-95c0-3613-9110-f94789534187
- Welter , R. , Herrmann , T. , Honselmann , S. , and Keller , J. Clutch Release Systems Schaeffler SYMPOSIUM 2010 94 111 2010
- ДСТУ ISO 7588-2:2007 June 2020
- Denton , T. Automobile Electrical and Electronic Systems Fifth Routledge 2018 978-1-315-85662-9
- Savchuk , V. , Bulgakov , N. , Kuhtov , V. , Simahin , A. et al. Providing Reliability of Sliding Bearings for Gearwheels of High-Loaded Transport Vehicles Power Transmissions During Operation SAE Technical Paper 2018-01-0794 2018 https://doi.org/10.4271/2018-01-0794
- Savchuk , V. , Kuhtov , V. , Gritsuk , I. , Podrigalo , M. et al. Providing of Sliding Bearings Reliability of Transmissions Gear Wheels of Transport Cars by Optimization of Assembly Tolerances SAE Technical Paper 2020-01-2239 2020 https://doi.org/10.4271/2020-01-2239
- Dadam , S.R. , Jentz , R. , and Meissner , H. Diagnostic Evaluation of Exhaust Gas Recirculation (EGR) System on Gasoline Electric Hybrid Vehicle SAE Technical Paper 2020-01-0902 2020 https://doi.org/10.4271/2020-01-0902
- Beversdorf , Scott , Whiting , Chuck Current Measurement in Solenoids for Automotive Control Systems Analog Dialogue 2004 https://www.analog.com/media/en/analog-dialogue/volume-38/number-2/articles/current-measurement-in-solenoids.pdf
- Myers , Bruce A. 2003 https://www.electronics-cooling.com/2003/08/cooling-issues-for-automotive-electronics/
- Johnson , R.W. , Evans , J.L. , Jacobsen , P. , Thompson , J.R. , and Christopher , M. The Changing Automotive Environment: High-Temperature Electronics IEEE Transactions on Electronics Packaging Manufacturing 27 3 164 176 July 2004 10.1109/TEPM.2004.843109
- Guo , Y.-X. , Lai , C. , Shao , Z.-B. , Xu , K.-L. , and Li , T. Differential Structure of Inductive Proximity Sensor Sensors 19 9 2210 2019 10.3390/s19092210
- May 2019
- http://www.kosmodrom.com.ua/prodlist.php?name=cap0805