This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Suspension hard points optimisation
ISSN: 0148-7191, e-ISSN: 2688-3627
To be published on November 21, 2019 by SAE International in United States
Event: NuGen Summit
Objective This paper explores the usage of Altair simulation driven optimisation process, Front Suspension hard points of a sedan Car model are optimised for specific target toe curves using MotionView, MotionSolve and HyperStudy This process gives the optimal hard point values to match the target curves without much iterations. Methodology Parametric Multibody model of the front end of sedan is built in MotionView. To Carry out optimisation HyperStudy is used where few of the suspension hard points which affect the toe curves are chosen as design variable. For the chosen Design variables upper and lower bound limits are specified. Ride, Roll and lateral force tests are performed. Optimisation is performed using HyperStudy where it iterates the suspension hard points to match the target toe curves. Each iteration response can be visualized in HyperStudy and can be compared with the target toe curve. Hyperstudy points the iteration which is closest to the Target curve Advantage • Quick model setup and run time • Parametric model allows quick change in design • Insight at early design stage • Manual iteration time is reduced Keywords: Suspension hard points, optimisation, Toe curve, Ride, Roll.