This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Nozzle Flow and Spray Development One-Way Coupling Methodology for a Multi-Hole GDi Injector
Technical Paper
2019-24-0031
ISSN: 0148-7191, e-ISSN: 2688-3627
This content contains downloadable datasets
Annotation ability available
Sector:
Language:
English
Abstract
The use of predictive models in the study of Internal Combustion Engines (ICE) allows reducing developing cost and times. However, those models are challenging due to the complex and multi-phase phenomena occurring in the combustion chamber, but also because of the different spatial and temporal scales in different components of the injection systems. This work presents a methodology to accurately simulate the spray by Discrete Droplet Models (DDM) without experimentally measuring the injector mass flow rate and/or momentum flux. Transient nozzle flow simulations are used instead to define the injection conditions of the spray model. The methodology is applied to a multi-hole Gasoline Direct injection (GDi) injector. Firstly, the DDM constant values are calibrated comparing simulation results to Diffused Back-light Illumination (DBI) experimental technique results. Secondly, transient nozzle flow simulations are carried out. The computational values of mass flow rate and momentum flux (therefore, the discharge and velocity coefficients) of the nozzle are obtained. Afterwards, they are used as an input for the spray DDM calculations. These computational spray results are again compared against the experimental data, showing that the liquid spray penetration into the combustion chamber is accurately predicted for a wide range of injection conditions in terms of injection pressure and ambient back density. It is also shown how the opening transient slope of the rate of injection plays a major role in predicting the early evolution of the spray, the first 10 mm of penetration.
Recommended Content
Authors
- Navid Shahangian - Toyota Motor Europe NV/SA
- Leila Sharifian - Toyota Motor Europe NV/SA
- Jun Miyagawa - Toyota Motor Corp
- Stefano Bergamini - AKKA
- Kazuhiro Uehara - Toyota Motor Corp
- Yasushi Noguchi - Toyota Motor Corp
- Pedro Marti-Aldaravi - Universitat Politecnica de Valencia
- María Martínez - Universitat Politecnica de Valencia
- Raul Payri - Universitat Politecnica de Valencia
Topic
Citation
Shahangian, N., Sharifian, L., Miyagawa, J., Bergamini, S. et al., "Nozzle Flow and Spray Development One-Way Coupling Methodology for a Multi-Hole GDi Injector," SAE Technical Paper 2019-24-0031, 2019, https://doi.org/10.4271/2019-24-0031.Data Sets - Support Documents
Title | Description | Download |
---|---|---|
Unnamed Dataset 1 | ||
Unnamed Dataset 2 | ||
Unnamed Dataset 3 | ||
Unnamed Dataset 4 |
Also In
References
- Schmidt , D. P. The Internal Flow of Diesel Fuel Injector Nozzles: A Review Int. J. Engine Res. 2 1 1 22 2001
- Payri , R. , Viera , J. P. , Gopalakrishnan , V. , and Szymkowicz , P. G. The Effect of Nozzle Geometry over Internal Flow and Spray Formation for Three Different Fuels Fuel 183 20 33 Nov. 2016
- Kong , S. C. , Senecal , P. K. , and Reitz , R. D. Developments in Spray Modeling in Diesel and Direct-Injection Gasoline Engines Oil Gas Sci. Technol. 54 2 197 204 1999
- Li , F. and Reitz , R. D. Spray and Combustion Modeling in Gasoline Direct-Injection Engines At. Sprays 10 219 249 2000
- Senecal , P. K. et al. Large Eddy Simulation of Vaporizing Sprays Considering Multi-Injection Averaging and Grid-Convergent Mesh Resolution J. Eng. Gas Turbines Power 136 11 111504 2014
- Dukowicz , J. K. A Particle-fluid Numerical Model for Liquid Sprays J. Comput. Phys. 35 2 229 253 1980
- Battistoni , M. et al. Experimental and Computational Investigation of Subcritical Near-Nozzle Spray Structure and Primary Atomization in the Engine Combustion Network Spray D SAE Int. J. Fuels Lubr 1 15 2018 10.4271/2018-01-0277
- Brusiani , F. , Bianchi , G. M. , and Tiberi , A. Primary Breakup Model for Turbulent Liquid Jet Based on Ligament Evolution SAE Technical Paper 2012-01-0460 2012 10.4271/2012-01-0460
- Befrui , B. , Aye , A. , Bossi , A. , Markle , L. E. , and Varble , D. L. ECN GDi Spray G : Coupled LES Jet Primary Breakup - Lagrangian Spray Simulation ILASS Am. 28th Annu. Conf. Liq. At. Spray Syst. May, 2016
- Duke , D. J. et al. Internal and near Nozzle Measurements of Engine Combustion Network ‘Spray G’ Gasoline Direct Injectors Exp. Therm. Fluid Sci. 88 608 621 2017
- Desantes , J. M. , Garcia-Oliver , J. M. , Pastor , J. M. , and Pandal , A. A Comparison of Diesel Sprays CFD Modeling Approaches: DDM Versus Σ-Y Eulerian Atomization Model At. Sprays 26 7 713 737 2016
- Saha , K. , Srivastava , P. , Quan , S. , Senecal , P. K. , and Som , S. Modeling the Dynamic Coupling of Internal Nozzle Flow and Spray Formation for Gasoline Direct Injection Applications SAE Technical Paper 2018-01-0314 1 13 2018 10.4271/2018-01-0314
- Desantes , J. M. , Garcia-Oliver , J. M. , Pastor , J. M. , Pandal , A. et al. Coupled/Decoupled Spray Simulation Comparison of the ECN Spray a Condition with the Σ-Y Eulerian Atomization Model Int. J. Multiph. Flow 80 89 99 2016
- Saha , K. , Quan , S. , Battistoni , M. , Som , S. et al. Coupled Eulerian Internal Nozzle Flow and Lagrangian Spray Simulations for GDI Systems SAE Technical Paper 2017-01-0834 2017 10.4271/2017-01-0834
- Zhang , J. , Yao , S. , Patel , H. , and Fang , T. An Experimental Study on Gasoline Direct-Injection Spray and Atomization Characteristics of Alcohol Fuels and Isooctane At. Sprays 21 5 363 374 2011
- Payri , R. , Gimeno , J. , Marti-Aldaravi , P. , and Vaquerizo , D. Internal Flow Characterization on an ECN GDi Injector At. Sprays 2016
- Payri , R. , Salvador , F. J. , Martí-Aldaraví , P. , and Vaquerizo , D. ECN Spray G External Spray Visualization and Spray Collapse Description through Penetration and Morphology Analysis Appl. Therm. Eng. 112 304 316 2017
- Manin , J. , Bardi , M. , and Pickett , L. M. 2012
- Meijer , M. , Malbec , L.-M. , Bruneaux , G. , and Somers , B. Engine Combustion Network: ‘Spray A ‘Basic Measurements and Advanced Diagnostics ICLASS 2012, 12th Triennial International Conference on Liquid Atomization and Spray Systems 2012 2 6
- Medina , M. , Fatouraie , M. , and Wooldridge , M. High-Speed Imaging Studies of Gasoline Fuel Sprays at Fuel Injection Pressures from 300 to 1500 Bar SAE Technical Paper 2018-01-0294 1 Cvc 1 18 2018 10.4271/2018-01-0294
- Huh , K. Y. and Gosman , A. D. 1991
- Reitz , R. D. and Beale , J. C. Modeling Spray Atomization with the Kelvin-Helmholtz/Rayleigh-Taylor Hybrid Model At. Sprays 9 6 623 650 2014
- Schmidt , D. P. and Rutland , C. J. A New Droplet Collision Algorithm J. Comput. Phys. 164 1 62 80 Oct. 2000
- Payri , R. , Gimeno , J. , Marti-aldaravi , P. , and Martínez , M. Nozzle Flow Simulation of GDi for Measuring Near-Field Spray Angle and Plume Direction SAE Technical Paper 2019-01-0280 1 11 2019 10.4271/2019-01-0280
- Sphicas , P. et al. A Comparison of Experimental and Modeled Velocity in Gasoline Direct-Injection Sprays with Plume Interaction and Collapse SAE Int. J. Fuels Lubr. 10 184 201 2017
- Lacaze , G. , Misdariis , A. , Ruiz , A. , and Oefelein , J. C. Analysis of High-Pressure Diesel Fuel Injection Processes Using LES with Real-Fluid Thermodynamics and Transport Proc. Combust. Inst. 35 2 1603 1611 2015
- Garcia-Oliver , J. M. , Pastor , J. M. , Pandal , A. , Trask , N. et al. Diesel Spray Cfd Simulations Based on the Σ-Υ Eulerian Atomization Model At. Sprays 23 1 71 95 2013
- Saha , K. , Som , S. , and Battistoni , M. Investigation of Homogeneous Relaxation Model Parameters and their Implications for Gasoline Injectors At. Sprays 27 4 345 365 2017
- Battistoni , M. , Duke , D. J. , Swantek , A. B. , Tilocco , F. Z. et al. Effects of Noncondensable Gas on Cavitating Nozzles At. Sprays 25 6 453 483 2015
- Manin , J. , Jung , Y. , Skeen , S. A. , Pickett , L. M. et al. Experimental Characterization of DI Gasoline Injection Processes SAE Technical Paper 2015-01-1894 Sep. 2015 10.4271/2015-01-1894
- Pope , S. B. An Explanation of the Turbulent Round-Jet/Plane-Jet Anomaly AIAA J. 16 3 279 281 2008
- Desantes , J. M. , Payri , R. , Salvador , F. J. , and Gil , A. Development and Validation of a Theoretical Model for Diesel Spray Penetration Fuel 85 7-8 910 917 2006