This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Effect of Using Exhaust Gas Recirculation (EGR) on the Emission Characteristics of the CI Engine Fuelled by Acetone-Butanol-Ethanol (ABE) Diesel Blends
ISSN: 0148-7191, e-ISSN: 2688-3627
Published April 02, 2019 by SAE International in United States
This content contains downloadable datasetsAnnotation ability available
The power generation, agriculture, and transportation sectors are dominated by diesel engines due to better thermal efficiency and durability. Diesel engines are also a major contributor to the air pollutants such as NOx and particulate matter. Acetone-butanol-ethanol (ABE) is considered a promising alternative fuel as it emits less pollutants compared to conventional fuels. In current work, the ABE used was of the ratio (3:6:1) and four samples were prepared for engine trial ABE (10%90%diesel), ABE (20%80%diesel), ABE (30%70%diesel) and ABE (40%60%diesel). Their physio-chemical properties like kinematic viscosity, density, specific gravity and calorific value were checked and tested on compression ignition engine at different operating parameters. The experimental work was conducted upon Kirloskar 4-stroke single cylinder, vertical, air-cooled 661cc compression ignition engine at different speeds and loads. The operational parameters taken were injection temperature, injection pressure and injection timings. The main aim of the current work is to find the effect of exhaust gas recirculation (EGR) on the emission characteristics of acetone-butanol-ethanol (ABE) blends with diesel in compressed ignition engine. Exhaust gas recirculation (EGR) is a promising technology to significantly decrease NOx emissions from diesel engines. The EGR reduces NOx by reducing the oxygen concentration in the combustion chamber, along with this through absorption of heat. The emission characteristics were evaluated using avl gas analyzer and the results were then compared with emission characteristics of ci engine when run with pure diesel
CitationMalhotra, A., Yadav, M., Tomar, M., Jain, S. et al., "Effect of Using Exhaust Gas Recirculation (EGR) on the Emission Characteristics of the CI Engine Fuelled by Acetone-Butanol-Ethanol (ABE) Diesel Blends," SAE Technical Paper 2019-01-0748, 2019, https://doi.org/10.4271/2019-01-0748.
Data Sets - Support Documents
|[Unnamed Dataset 1]|
|[Unnamed Dataset 2]|
|[Unnamed Dataset 3]|
|[Unnamed Dataset 4]|
- Herzog, C. and Fryszman, A., “Perspectives for the Utilization of Renewable Fuels in Latin America,” SAE Technical Paper 911709, 1991, doi:10.4271/911709.
- McCormick, R.L. and Parish R., “Milestone Report: Technical Barriers to the Use of Ethanol in Diesel Fuel,” Report NREL/MP- 540-32674, National Renewable Energy Laboratory, Golden, CO, 2001.
- Agathou, M., Powell, J., Lee, C., and Kyritsis, D., “Preliminary Experimental Study of Butanol Electrosprays for Power Generation,” SAE Technical Paper 2007-24-0020, 2007, doi:10.4271/2007-24-0020.
- Qureshi, N. and Blaschek, H.P., “Recovery of Butanol from the Fermentation Broth by Gas Stripping,” Renewable Energy 22(4):557-564, 2001.
- Lee, T., Lin, Y., Meng, X., Li, Y. et al., “Combustion Characteristics of Acetone, Butanol, and Ethanol (ABE) Blended with Diesel in a Compression-Ignition Engine,” SAE Technical Paper 2016-01-0884, 2016, doi:10.4271/2016-01-0884.
- Marszalek, J. and Kaminski, W.L., “Efficiency of Acetone Butanol Ethanol-Water System Separation by Pervaporation,” Chem. Process Eng. 33(1):131-140, 2012, doi:10.2478/v10176-012-0012-3.
- Chang, Y.C., Lee, W.J., Lin, S.L., and Wang, L.C., “Green Energy: Water-Containing Acetone-Butanol-Ethanol Diesel Blends Fueled in Diesel Engines,” Appl Energ 109(2):182-191, 2013, doi:10.1016/j.apenergy.2013.03.086.
- Chang, Y.C., Lee, W.J., Wu, T.S., Wu, C.Y. et al., “Use of Water Containing Acetone-Butanol-Ethanol for NOx-PM (Nitrogen Oxide-Particulate Matter) Trade-Off in the Diesel Engine Fueled with Biodiesel,” Energy. 64(1):678-687, 2014, doi:10.1016/j. energy.2013.10.077.
- Wu, H., Nithyanandan, K., Zhou, N., Lee, T. H., Lee, C. F., Zhang, C., “Impacts of Acetone on the Spray Combustion of Acetone-Butanol-Ethanol (ABE)-Diesel Blends under Low Ambient Temperature”, Fuel 142, 15 February 2015, Pages 109-116, ISSN 0016-2361
- Lin, Y., Wu, H., Nithyanandan, K., Lee, T. H., Lee, C. F., and Zhang, C., “Investigation of High Percentage Acetone Butanol Ethanol (ABE) Blended With Diesel in a Constant Volume Chamber,” in Proc. ASME. 46162; Volume 1: Large Bore Engines; Fuels; Advanced Combustion; Emissions Control Systems, V001T02A012, October 19, 2014, ICEF2014-5649, 10.1115/ICEF2014-5649.
- Lee, T., Lin, Y., Wu, H., Meng, L. et al., “Characterization Spray and Combustion Processes of Acetone-Butanol-Ethanol (ABE) in a Constant Volume Chamber,” SAE Technical Paper 2015-01-0919, 2015, doi:10.4271/2015-01-0919.
- Lee, T. H., Lin, Y., Nithyanandan, K., Zhang, J., Li, Y., Yang, J., Hansen, A. C., Lee, C. et al., “Experimental Investigation of A Diesel Engine Fuelled with Acetone- Butanol- Ethanol/ Diesel Blends,” in Proceedings of the ASME 2015 Internal Combustion Engine Division Fall Technical Conference, Houston, TX, November 2015 (Accepted)
- Zhou, N., Huo, M., Wu, H., Nithyanandan, K. et al., “Low-Temperature Spray Combustion of Acetone-Butanol-Ethanol (ABE) and Diesel Blends,” Appl. Energy 117:104-115, 2014, doi:10.1016/j.apenergy.2013.11.035.
- Wu, H., Huo, M., Zhou, N., Nithyanandan, K. et al., “An Experimental Investigation of the Combustion Characteristics of Acetone-Butanol-Ethanol-Diesel Blends with Different ABE Component Ratios in a Constant Volume Chamber,” SAE Technical Paper 2014-01-1452, 2014, doi:10.4271/2014-011452.
- Nithyanandan, K., Wu, H., Huo, M., and Lee, C., “A Preliminary Investigation of the Performance and Emissions of a Port-Fuel Injected SI Engine Fueled with Acetone-Butanol-Ethanol (ABE) and Gasoline,” SAE Technical Paper 2014-01-1459, 2014, doi:10.4271/2014-01-1459.
- Chang, Y.C., Lee, W.J., Lin, S.L., and Wang, L.C., “Green Energy: Water-Containing Acetone-Butanol-Ethanol Diesel Blends Fueled in Diesel Engines,” Appl. Energ 109(2):182-191, 2013, doi:10.1016/j.apenergy.2013.03.086.
- Chang, Y.C., Lee, W.J., Wu, T.S., Wu, C.Y. et al., “Use of Water Containing Acetone-Butanol-Ethanol for NOx-PM (Nitrogen Oxide-Particulate Matter) Trade-Off in the Diesel Engine Fueled with Biodiesel,” Energy 64(1):678-687, 2014, doi:10.1016/j. energy.2013.10.077.
- Ramana, P.V. et al., “Effect of EGR on C.I Engine Emissions and Cooling Rate Using Diesel and Ethanol Blend,” International Journal of Advanced Research in Engineering and Applied Sciences ISSN: 2278-6252
- Lamani, V.T. et al., “Effect of Exhaust Gas Recirculation Rate on Performance, Emission and Combustion Characteristics of a Common-Rail Diesel Engine Fuelled with n-Butanol-Diesel Blends,” ISSN: 1759-7269 (Print) 1759-7277 (Online) Journal homepage: http://www.tandfonline.com/loi/tbfu20.
- Kumar, V., Gupta, D., Naseer Siddiquee, M., Nagpal, A. et al., “Performance and Emission Characteristics of n-Butanol and Iso-Butanol Diesel Blend Comparison,” SAE Technical Paper 2015-01-2819, 2015, doi:10.4271/2015-01-2819.
- Talalyusuf et al, “Impact of the Acetone-Butanol Mixture as a Fuel Additive on Diesel Performance and Emissions,” 10.1016/j.fuel.2018.04.091.