This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Effect of Ashless Dispersant on the Morphology, Size, Nanostructure and Graphitization Degree of Diesel Exhaust Particles
ISSN: 0148-7191, e-ISSN: 2688-3627
Published April 03, 2018 by SAE International in United States
This content contains downloadable datasetsAnnotation ability available
The aim of this research is to investigate the effects of ashless dispersant of lube oils on diesel exhaust particles. Emphasis is placed on particle size, morphology, nanostructure and graphitization degree. Three kinds of lube oils with different percentages of ashless dispersant were used in a two-cylinder diesel engine. Ashless dispersant (T154), which is widely used in petrochemical industry, were added into baseline oil at different blend percentages (4.0% and 8.0% by weight) to improve lubrication and cleaning performance. A high resolution Transmission Electron Microscope (HRTEM) and a Raman spectroscopy were employed to analyze and compare particle characteristics. According to the experiment results, primary particles diameter ranges from 3 nm to 65 nm, and the diameter distribution conformed to Gaussian distribution. When the ashless dispersant was used, the primary particles diameter decrease obviously at both 1600 rpm and 2200 rpm. Besides, particles when high percentages ashless dispersant lube oil was used show same chain-like and branch-like cluster. At the nanoscale level, particles show shell-core and urbostratic structures. Particles when higher percentages ashless dispersant lube oil was used show more ordered structures with longer fringe length and lower fringe tortuosity. As to the graphitization degree, the area ratio of the first defect band to graphite band decreases when the ashless dispersant was added into baseline lube oil at both 1600 rpm and 2200 rpm. Particles when higher percentages ashless dispersant was used are likely less relative because of the relatively higher graphitization degree, longer fringe length and lower fringe tortuosity.
CitationWang, Y., Liang, X., Wang, Y., Sun, X. et al., "Effect of Ashless Dispersant on the Morphology, Size, Nanostructure and Graphitization Degree of Diesel Exhaust Particles," SAE Technical Paper 2018-01-0636, 2018, https://doi.org/10.4271/2018-01-0636.
Data Sets - Support Documents
|[Unnamed Dataset 1]|
|[Unnamed Dataset 2]|
- Wu, S., Yang, D., Pan, L., Shan, J. et al. , “Chemical Constituents and Sources of Ambient Particulate Air Pollution and Biomarkers of Endothelial Function in a Panel of Healthy Adults in Beijing, China,” Science of the Total Environment 560-561:141-149, 2016.
- Raaschounielsen, O., Beelen, R., Wang, M. et al. , “Particulate Matter Air Pollution Components and Risk for Lung Cancer,” Environment International 87(5):66-73, 2016.
- Li, X., Guan, C., Luo, Y., and Huang, Z. , “Effect of Multiple-Injection Strategies on Diesel Engine Exhaust Particle Size and Nanostructure,” Journal of Aerosol Science 89:69-76, 2015.
- Wang, C., Xu, H., Herreros, J.M., Wang, J. et al. , “Impact of Fuel and Injection System on Particle Emissions from a GDI Engine,” Applied Energy 132(132):178-191, 2014.
- Pietikäinen, M., Väliheikki, A., Oravisjärvi, K., Kolli, T. et al. , “Particle and NOx Emissions of a Non-road Diesel Engine with an SCR Unit: The Effect of Fuel,” Renewable Energy 77:377-385, 2015.
- Pakbin, P., Ning, Z., Schauer, J.J., and Sioutas, C. , “Characterization of Particle Bound Organic Carbon from Diesel Vehicles Equipped with Advanced Emission Control Technologies,” Environmental Science and Technology 43(13):4679-4686, 2009.
- Hu, S., Herner, J.D., Shafer, M., Robertson, W. et al. , “Metals Emitted from Heavy-Duty Diesel Vehicles Equipped with Advanced PM and NOX Emission Controls,” Atmospheric Environment 43(18):2950-2959, 2009.
- Dong, L., Shu, G., and Liang, X. , “Effect of Lubricating Oil on the Particle Size Distribution and Total Number Concentration in a Diesel Engine,” Fuel Processing Technology 109(7):78-83, 2013.
- Wang, Y., Liang, X., Shu, G., and Dong, L. , “Impact of Lubricating Oil on Morphology of Particles from a Diesel Engine,” Energy Procedia 75:2388-2393, 2015.
- Wang, Y., Liang, X., Wang, K., Wang, Y. et al. , “Effect of Base Oil on the Nanostructure and Oxidation Characteristics of Diesel Particulate Matter,” Applied Thermal Engineering 106:1311-1318, 2016.
- Hilden, D.L. and Mayer, W.J. , “The Contribution of Engine Oil to Particulate Exhaust Emissions from Light-Duty,” SAE Technical Paper 841395, 1984, doi:10.4271/841395.
- Dowling, M. , “The Impact of Oil Formulation on Emissions from Diesel Engines,” SAE Technical Paper 922198, 1992, doi:10.4271/922198.
- Andersson, J.D., Preston, H., Warrens, C. et al. , “Lubricant Composition Impact on the Emissions from a European Heavy Duty Diesel Engine Equipped with a Diesel Particulate Filter,” SAE Technical Paper 2004-013012, 2004, doi:10.4271/2004-013012.
- Arthurl, L.M., Christopher, B.S., Matthew, C.H. et al. , “Role of Lubrication Oil in Particulate Emissions from a Hydrogen-Powered Internal Combustion Engine,” Environmental Science & Technology 41(19):6828-6835, 2007.
- Worton, D.R., Isaacman, G., Gentner, D.R., Dallmann, T.R. et al. , “Lubricating Oil Dominates Primary Organic Aerosol Emissions from Motor Vehicles,” Environmental Science & Technology 48(7):3698-3706, 2014.
- Wu, Z., Song, C., Lv, G., Pan, S. et al. , “Morphology, Fractal Dimension, Size and Nanostructure of Exhaust Particles from a Spark-Ignition Direct-Injection Engine Operating at Different Air-Fuel Ratios,” Fuel 185:709-717, 2016.
- Sadezky, A., Muckenhuber, H., Grothe, H., Niessner, R. et al. , “Raman Microspectroscopy of Soot and Related Carbonaceous Materials: Spectral Analysis and Structural Information,” Carbon 43(8):1731-1742, 2005.