This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Simultaneous Measurement of Fuel Droplet Deposition Amount and Oil Film Thickness on Spray Impingement Using Double Laser Induced Fluorescence Method
Technical Paper
2017-01-2371
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
Diesel Particulate filter (DPF) is installed as after treatment device of exhaust gas in diesel engine, and collects the Particulate Matter (PM). However, as the operation time of engine increases, PM is accumulated in the DPF, resulting in deterioration of PM collection efficiency and increasing in pressure loss. Therefore, Post injection has been attracted attention as DPF regeneration method for burning and removing PM in DPF. However, Post injection causes oil dilution when fuel is injected at the middle to late stage of expansion stroke. Oil dilution are concerned to deteriorate the sliding property of piston and the thermal efficiency. For this reason, it is necessary to elucidate the mechanism and the behavior that spray impinges lubricating oil film. Therefore, in this study, we aimed to construct model of Computational Fluid Dynamics (CFD) that predicts amount of oil dilution which is concern for post injection in diesel engine, with high accuracy. In this report, we constructed Double Laser Induced Fluorescence (DLIF) applying LIF. In the DLIF, two kinds of fluorescent dyes were dissolved to diesel fuel and engine oil respectively, and Ultraviolet (UV) -LED was used as excitation light. Each fluorescence wavelength was spectrally separated at a specific wavelength. DLIF makes it possible to simultaneously and continuously measure fuel film thickness and oil film thickness in the case of diesel spray impinging lubricating oil film. As the result of measurement using DLIF, it was found that a large difference of deposition amount which fuel spray impinges dry wall and lubricating oil film. Due to influence of lubricating oil film, deposition area and deposition amount decreases compared with dry wall.
Recommended Content
Authors
Topic
Citation
Kambe, H., Mizobuchi, N., and Matsumura, E., "Simultaneous Measurement of Fuel Droplet Deposition Amount and Oil Film Thickness on Spray Impingement Using Double Laser Induced Fluorescence Method," SAE Technical Paper 2017-01-2371, 2017, https://doi.org/10.4271/2017-01-2371.Also In
References
- Espey , C. , Dec , J. , Litzinger , T. , and Santavicca , D. Quantitative 2-D Fuel Vapor Concentration Imaging in a Firing D.I. Diesel Engine Using Planar Laser-Induced Rayleigh Scattering SAE Technical Paper 940682 1994 10.4271/940682
- Nishijima , Y. , Asaumi , Y. and Aoyagi , Y. Analysis of Combustion Chamber Bottom Wetting on Diesel Splay Atomaization : journal of the ILASS-Japan 11 36 161 169
- Katsuura , N. , Saito , M. , Senda , J. and Fujimoto , H. Characteristics of diesel spray impinging on a flat wall (2 nd report) The Japan Society of Mechanical Engineers, Series B 56 521 227 234 1990
- Kanda , T. , Kobayashi , M. , Senda , J. and Fujimoto , H. Quantitative Analysis of Fuel Concentration Fields in Diesel Spray. (2nd Report. Vapor Concentration Distribution in Impinging Spray and Quantitative Analysis for Liquid Phase Concentration) The Japan Society of Mechanical Engineers, Series B 63 607 328 333 1997
- Okamoto , S. , Kawashima , H. , Ishima , T. and Nakama , K. Analysis of the fuel adhering to a model engine cylinder by using time series LIF methods 12th Triennial International Conference on Liquid Atomization and Spray Systems 2012
- Uchida , R. , Tanaka , D. , Noda , T. , Okamoto , S. et al. Impingement Behavior of Fuel Droplets on Oil Film SAE Technical Paper 2015-01-0913 2015 10.4271/2015-01-0913
- Kouchi , S. , Okamoto , S. , Ozawa , K. , Kawashima , H. et al. Observation and Analysis of Behavior of Spray Impingement on a Liquid Film SAE Technical Paper 2015-01-2006 2015 10.4271/2015-01-2006
- Seel , K. , Reddemann M.A. , Baltaci , T. and Kneer , R. Impact of lubricating oil films on spray-wall interaction Powertrains Fuels and Lubricants Jan. 2015
- Gomaa , H. , Stotz , I. , Sievers , M. , Lamanna , G. and Weigand , B. Preliminary Investigation on Diesel Droplet Impact on Oil Wallfilms in Diesel Engines 24th ILASS 2011 2011
- Senda , J. , Ohnishi , M. , Takahashi , T. , Fujimoto , H. et al. Measurement and Modeling on Wall Wetted Fuel Film Profile and Mixture Preparation in Intake Port of SI Engine SAE Technical Paper 1999-01-0798 1999 10.4271/1999-01-0798
- Inagaki , H. , Saito , A. , Murakami , M. and Konomi , T. Measurement of Oil Film Thickness Distribution on Piston Surface Using Fluorescence Method (Development of Measuring System) The Japan Society of Mechanical Engineers, Series B 61 590 231 237 1995
- Iida , M. , Yoshikawa , K. , Tanaka , H. , Wang , G. et al. Fuel Film Behavior Analysis Using Simulated Intake Port SAE Int. J. Engines 2 2 756 763 2010
- Almkvist , G. , Denbratt , I. , Josefsson , G. , and Magnusson , I. Measurements of Fuel Film Thickness in the Inlet Port of an S.I. Engine by Laser Induced Fluorescence SAE Technical Paper 952483 1995 10.4271/952483
- Saeki , S. , Hart Douglas P. and Hidrovo Carlos H. Spectroscopic Study on YAG (532) Laser Dyes using DELIF for Oil Film Thickness and Temperature Measurement Journal of the Visualization Society of Japan 21 19 20
- Suzuki , H. , Ishima , T. , Obokata , T. Oil Film Visualization on the Piston used in Gasoline Engine Journal of the Visualization Society of Japan 30 142 147
- Sanda , S. and Saito , A. Analysis of Piston Oil Film Behavior by Using Laser Induced Fluorescence Toyota Central R&D Lab. Review 28 4 1993